where is cam senor on a 91 cutlass ciera 3300
The starter on a 1994 Oldsmobile Cutlass Ciera is located on the driver's side of the engine towards the bottom of the engine. It is behind the crankshaft sensor and the fusible links.
The low pressure valve to put in 134a on a 1994 Oldsmobile Cutlass Ciera V6 is on the passenger side of the engine compartment. It is about 12 inches below the alternator.
Low refrigerant? Blown Fuse?
underneath the green and red stripy cats hat by doctor seus
cracked or broken wiring, blown fuse
you would use 5W-30W have the same car
I believe that is a 15 mm bolt.
i need picture of 94 cutlass ceira rear brake assembly
The 1994 Oldsmobile Cutlass turn signal relay switch can be found below the dashboard. The relay switch will be on the drivers side of the passenger compartment.
you get in and drive
the horn relay switch is in the fuse panel or it should be on the horn wires itself
The 1994 Oldsmobile Cutlass cam sensor is located on the back of the left cylinder head. The cam sensor should be labeled as such.
OPEN THE GLOVE BOX. YOU WILL SEE A SMALL DOOR TO THE Left. that's the hiding place of the fuses..
R- 12, gm didnt switch over to 134/a until 1994 model year
yes water is coming out of this little hole in the water pump
it's called a serpentine belt.
try replacing the coolent temp sensor
The 1994 GM A Body vehicles with the 3.1 requires 41 to 47 psi for fuel pressure.
This space is too small to list the instructions. Go to the link I will post on the bottom left for detailed instructions.
Check the brake light switch, it's under the dashboard, connected to the brake pedal.
I have yet to identify which relay is specifically for the fuel pump,however, the relays are mounted on the passenger side of the radiator .
10/22-inch Dayton Rams with trues and Vogue tires on a 1994 Cutlass supreme
There were a reported 8,638 Olds Cutlass Supreme convertibles sold in 1994