Want this question answered?
does anyone know this answer does anyone know this answer
Well yes there is its called electricians conduit measuring tool we found it on u tube . go to superconduits and watch the video .
Wire in conduit for underground feeders has to have an insulationrating for wet and damp locations. In the marketplace there is also wiring thathas an insulation rating for direct burial that does not need to be installed into conduit.
Yes, it must have a standoff, and the proper service head in. I would run it underground instead of overhead. Use underground wire in a conduit.
According to the wording ,2 different phase wires "can" run through the same conduit. Not only can they, but if they are part of the same circuit they must. And in cases where conductors are paralleled, meaning more than one conductor per phase as is common in commercial and industrial installations, you put one conductor of each phase and a neutral, if one exists, and a ground in each conduit. Not doing so, meaning to put all of one phase in one conduit, causes a voltage to be induced into the conduit and a tremendous amount of heat builds up. Even when using pvc or other non-metallic conduit, somewhere along the way you have something metallic and have the same problem. To simplify, you must put all conductors associated with the same circuit in the same conduit.
ya the galvanized pipecan be use in undergrounds,,, because it is an iron pipe
intermediate galvanized conduit
intermediate galvanized conduit
does anyone know this answer does anyone know this answer
For underground conduit runs, PVC is by far the better of the two conduit systems.
does anyone know this answer does anyone know this answer
Simply put, no. The long answer: The process of chrome plating involves the chromium actually bonding to the metal substrate through an entergetic reaction. Galvanizing metal introduces a layer of zinc oxide into the mix which would contaminate the plating process. The chrome would actually split bond to the zinc and possibly somewhat to the substrate. This would cause the zinc to lose its bond with the metal substrate. If it all stayed intact the part would, at first, appear to be chrome plated, but due to the zinc oxide contamination it will flake off easily. I hope this is a sufficient answer to your query.
Well yes there is its called electricians conduit measuring tool we found it on u tube . go to superconduits and watch the video .
PVC conduit is recommended for underground installations. Just remember that a ground wire equal to the maximum load current of the device connected at the other end has to be installed. This ground wire is not counted in conduit fill calculations. It has to have a green insulation in colour and be of a continuous length.
Wire in conduit for underground feeders has to have an insulationrating for wet and damp locations. In the marketplace there is also wiring thathas an insulation rating for direct burial that does not need to be installed into conduit.
The outer casing of an Ethernet cable does not have a UV rating and will deteriorate under the summer sun. Pull the cable into a conduit and if possible bury the conduit underground. This will give you a safe and secure link.
The best time to install conduit is before the plumbers and sheet metal trades get into the building. <<>> In underground installations before the trench gets back filled.