It can but it is not a good idea to to so. The heat emitted by the base board heater rises. Any wiring coming into contact with this heat will have to be de rated to a lower ampacity.
Baseboard electric heaters are placed on the outer walls of a room in order to radiate heat towards the center of the room. They also heat up the outer walls of which usually are cooler than the inner walls.
resistors, variable potentiometers
lol CEA i was looking for the answer too hahaha, i love you guys!!! (and PLTW) but here's the answer!!! 1. Sometimes electrical plans are placed on a separate sheet because things are very detailed and would be cluttered if they tried to fit it on a floor plan.
The term "wall cavity" usually refers to the space between studs. Outlet boxes are usually fastened to one side of a stud or the other. Sometimes they are fastened to a crossbar, whether metal or wood, so they can be placed anywhere within the space. There are height limitations in order to count as required outlets but may be placed anywhere you need one. They are called convenience outlets and my friends often hear me say that if one isn't convenient, there aren't enough. If by "wall cavity" you mean a completely walled off portion of a building with no access, something that sometimes happens in commercial buildings, then no, it is not legal. You must have access to any splices in the circuit, which includes end of the line.
Electrical Design entails planning, creating, testing or supervising the development and installation of electrical equipment, including lighting design, power systems, power distribution, fire and life safety systems, electronic components and voice and data communications infrastructure. Typically, an Electrical Design position is held by an electrical engineer who has a bachelor's degree or even a Master of Science in Electrical Engineering. The electrical equipment may be placed in commercial, educational, industrial, hospitality, residential, medical or government facilities.
The outlet would be the more often recommended place for it.An electrical timer can be placed anywhere within the circuit. Usually the timer would be placed at the front end of the circuit.
An electrical outlet can not be placed behind a sink. If the outlet is witin 6 feet of a sink it must be GFI protected.
It doesn't matter just make sure that the receptacle is of a GFCI type.
Baseboard electric heaters are placed on the outer walls of a room in order to radiate heat towards the center of the room. They also heat up the outer walls of which usually are cooler than the inner walls.
Answer for botanyThe receptacle is the part at the bottom of a flower, that forms the base of the flower, that holds the rest up.Answer for electrical wiringA receptacle is what the plugs of electrical appliances can be plugged into.
A thermostat for heating or a thermometer for air temperature is typically placed on an inside wall (not outside wall), and away from heating vents or direct sunlight.
It can be called either baseboard or baseshoe depending on where you're from. If you're installing vinyl flooring the trim piece is called quarter round and it attaches to the bottom edge of cabinets where you wouldn't have a baseboard installed.
When heating a substance over a Bunsen burner the iron clamp for test tubes or the wire gauze is placed on top of the iron ring for beakers.
yes
Heating vents should be placed near or on the floor in a room because heat travels up not down.
over a blue flame
on the floor on the floor