Yes you can. Think about a large LED clock display - each segment of the lines that make up the numbers, is a string of LED's connected in parallel - so they all light up at the same time.
Squares, rectangles, parallelograms and rhombuses have two parallel sides. The other two are also parallel. A trapezium has only two parallel sides.
Two sides of a quadrilateral can be parallel.
a trapezoid
trapezoid
A trapezium has two parallel sides (of unequal length) and two non-parallel sides.
Basically, when LEDs are connected in parallel, the LEDs with the lowest resistance will be the brightest, the other LEDs will be dimly lit or not lit at all. Therefore, use LEDs with the same model number and colour.
A: LEDS are devices that needs a certain voltage and current typically 1.8 and 20 ma
With capacitors in parallel you can just add the microfarads.
Start at the positive post of the battery put a fuse no more than 1 foot away from it after the fuse you can run the wire to wherever you want to put your switch hook that wire to on terminal on your switch then run a wire to wherever you want to put your lites. If the LEDs are in series use that 1 wire and hook it to the red or white wire on the first of your lites via an appropriate value resistor then join the negative lead to the positive of the next LED. Continue until all the LEDs are connected. Connect the negative lead of the last LED to ground. If the LEDs are wired in parallel follow the manufacturers instructions.
With great difficulty. Or to put it another way, you also need to know the distance between the two parallel sides and the offset of the two parallel sides.
If your compairing apples to apples like 3 watt leds to 3w leds then 128. The more leds the higher the power.
A square has parallel sides. A rectangle has parallel sides.
When two lines are parallel, then they do not intersect.
You can't. Two 4 ohm speakers in parallel equal 2 ohms, and two in series equal 8 ohms. It is possible to wire four 4 ohm speakers so that the load is 4 ohms though. Put two in series (8 ohms). put the other two in series (8 ohms). Then put the two sets in parallel (two 8 ohm sets in parallel equal 4 ohms).
2There are two parallel sides....A rhombus has two pairs of opposite parallel sides.There are two parallel sides....A rhombus has two pairs of opposite parallel sides.
Squares, rectangles, parallelograms and rhombuses have two parallel sides. The other two are also parallel. A trapezium has only two parallel sides.
not enuff information 20 leds in parallel at 2.5v about 2W a motor at 480V 3 phase 600 w or 3/4 hp