0
If you have a 100-amp breaker box on the pole with a 100-amp breaker going to your house and you get a hot tub that needs a 60-amp GFI breaker would that overload the box?
Wiki User
∙ 18y ago
That's pushing it but it can work. It depends if you have central A/C, electric range, water heater, etc. Those are your amp suckers. You'll need to be mindful when operating the hot tub; not running the dryer, oven, or other large appliances.
Wiki User
∙ 18y ago
Add your answer:
Earn +20 pts
Why would a circuit breaker switch spark?
the circuit breaker spark when it comes an over load, loss contact,but the probable cause is loss contact...and also the circuit breaker is going to be damage or destroyed.
Can a 40 amp breaker not a 4 amp breaker be used to replace a 35 amp breaker for ac unit?
Depends on the size of the wire going to the A/C. If the wire is AWG #10 you cannot install a 40 amp breaker. If the wire is AWG #8 you can.
How do you tell if a household circuit breaker is defective?
Safety First! 1) Remove all load devices from the breaker circuit (unplug everything). 2) Reset breaker and observe. No problem, move to step three. 3) Add back one load device at the time. If it's winter, and the device that reproduces the problem happens to be a space heater, stop here, you solved the problem. Move the space heater to a less populated circuit. 4) If you add your I-Pod charger and the breaker trips, you could still need an licensed professional to investigate. In my experience (almost 39 years) doing electrical work, circuit overload is the most common cause.
100 amp breaker on outside pole what causes power to shut off or lights flickering?
Well the most probable answer is that you are exceeding your electrical load limits. This means that all the circuits on that 100amp breaker, i.e. ligts, outlets,etc are drawing more than the 100 amps you have available. You can most likely fix this by installing a higher amp main breaker, however if you do that you also need to check and possible install larger circuit breakers. Also you might want to check all your grounding and make sure you actually have all your outlets and lighting going to "earth ground", and if you have any GFCI circuits which would be in the bathroom or the kitchen and they are tripping due to excess amp draw or a short, this also could be a possiblilty.
Found 2 wires on a single circuit breaker why?
If it was two wires under one screw on a single-pole breaker, that would not be proper, and most probably against electrical code.If it was two wires, each under their own screw on a double-pole breaker, then that would be a 220 volt circuit; each wire going to its own "leg" of the breaker panel.
Is it unsafe to have 60A service going into a new electrical box designed for 100A?
Its not recommended because your new main breaker will allow up to 100 amps and your old wire can only safely handle 60amps. If you put a 60amp main breaker in the new box, that would be acceptable. No, it is perfectly safe. Because the box is overrated, there is no problem. If the box is the main panel, and not a subpanel, install a 60A main breaker so you cannot overload your service. If it is a subpanel this 60A breaker should be in the main panel.
If you have a 125 amp breaker box on the pole with a 125 amp breaker going to your house and you get a hot tub that needs a 60 amp GFI breaker would that overload the box?
It depends on what else you are running in the house. Add up your amperage to see if it is more than the 125amp rating. Which should be below 105 amps constant to keep from overheating the main breaker. If you are not running a big central ac system or a electric oven and water heater you should have no problem running the hot tub.
What is is a breaker?
A person or thing that is going to break A person or thing that is going to break
Why do the fuses keep going out in your 93 Honda civic?
Overload or short in system
Why does your sump pump breaker alarm keep going off?
The sump pump breaker alarm will keep going off if it is being overloading. This is usually a result of a failing pump or a clogged filter.
Why would a circuit breaker switch spark?
the circuit breaker spark when it comes an over load, loss contact,but the probable cause is loss contact...and also the circuit breaker is going to be damage or destroyed.
What one is better fuse or circuit breaker?
IMO it would be because the circuit breaker has the possibility of going bad and not working (allowing a short to move through the device), but fuses blow (cause a break) no matter what if shorted.
Can a 40 amp breaker not a 4 amp breaker be used to replace a 35 amp breaker for ac unit?
Depends on the size of the wire going to the A/C. If the wire is AWG #10 you cannot install a 40 amp breaker. If the wire is AWG #8 you can.
What happens to power if more current pass?
the amount of power going to the object will will cause the circut breaker to blow. if the object is not connected to a breaker then the object will catch on fire.
What will cause a star delta panel to trip in delta?
On a star delta starter a motor overload or a motor going to ground and cause a short circuit will cause the overload protection to trip. These overloads have to be reset before the motor can be restarted.
How do you tell if a household circuit breaker is defective?
Safety First! 1) Remove all load devices from the breaker circuit (unplug everything). 2) Reset breaker and observe. No problem, move to step three. 3) Add back one load device at the time. If it's winter, and the device that reproduces the problem happens to be a space heater, stop here, you solved the problem. Move the space heater to a less populated circuit. 4) If you add your I-Pod charger and the breaker trips, you could still need an licensed professional to investigate. In my experience (almost 39 years) doing electrical work, circuit overload is the most common cause.
What would be the cause and solution of partial electricity going out if wires may have touched when fixing a closet switch?
Blown fuse or tripped breaker. Replace the fuse or reset the breaker.
