answersLogoWhite

0


Best Answer

yes wires is electrical panel

User Avatar

Wiki User

11y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Can you splice wires in an electrical panel?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What are connecting wires?

Connecting wires in electrical terms is called an electrical splice. All electrical splices have to be made in a junction box.


What are the differences between electrical splices and electrical joints?

A splice usually refers to joining wires in some fashion. Someone could refer to a splice as an electrical joint, but term joint might be better applied to an electrical terminal or connection point.


How do you splice a ground wire?

Strip the wires back about 3/4" and then using lineman's pliers twist the wires together about 2 turns. Tighten a wire nut securely to the connection. Then tape the splice securely with electrical tape.


How do you replace the radio in a 1984 Beretta?

Buy a harness for your vehicle... splice the wires together by color.. wrap them in electrical tape =)


How do you conect the wires to the electric windows the wires have been cut?

Match the wires by their color codes and splice them together with splice connectors and a crimping tool.


What is the procedure for splicing home service wires?

The electrical code states that any splice in a wire, the insulation over the splice has to be equal to or greater than the insulation on that of the rest of the wire. So what ever type of splice that you use make sure that you insulate it well.


What is the rat tail joint?

A rat tail joint, more commonly called a rat-tail splice a very basic electrical splice used to connect two or more wires by wrapping them symmetrically around a common axis. It is not a mechanically strong splice and is intended for wires that are protected inside an enclosure or junction box.


2004 venture Inside door lock switch not working?

If its the drivers door lock switch not working, 99 times out of 100 the problem is a corroded/broken splice in the wires. The wires/splice run under the passenger side carpet. Remove the passenger side plastic door-sill plate and pull up the carpet revealing the wire harness. Unwrap the electrical tape, find the solid white wire and solid light-blue wire. On the white and blue wire there is a splice(wrapped in electrical tape) with 2 wires splicing into one wire. You will need to remove the electrical tape and most likely you will find the splice is corroded or completely broken(due to water leaking inside-another story). Cut out the corroded wire and splice in a new piece of wire, wrap in electrical tape and you should be good to go.


Can you splice branch circuit conductors with wire nuts inside sub panels if the wires are too short to reach the bar?

No, the electrical code disallows distribution panels to be used for splicing of conductors or to be used as a raceway for through conductors. Some inspectors will allow the use of butt splices, properly installed with the correct tool and finally wrapped with electrical tape. Before the job is started inquire at the Electrical Inspection Agency for their thoughts. <<>> You will be better off to splice the wires at some point outside the panel in a junction box (J-box). This method will be legal under most (perhaps all) electrical codes and will allow easier access.


Can you run supply pipes hot and cold and drain pipe under electrical panel?

As long as the wires are fed to the panel from above.


What are the required for electrical panel?

The main items required for an electrical panel include the panel box itself, fuses, and wiring. The wires are fed into the box and attached to a series of circuit breakers to allow electricity to be directed as needed.


What are the different kind of joints and splicing?

One type of electrical joint is known as a western splice. Another type of mechanical joint is known as a butt splice where a device is installed in series with the wires to be connected and then crimped with a crimping tool. Another type for combining wires together uses a device known as a wire nut.