it would be 9 times yesterday's power output
1. If you do work on an object in one-third the usual time, your power output is A) one third the usual power output. B) the usual power output. C) three times the usual power output. D) impossible to predict without additional information. Answer: C
effciency
100 times less
A 10-20 vdc power source is a low output power supply used for small devices like battery chargers, notebook computers, and appliances. They use AC power input to convert it into DC power.
A joule is a unit of energy, not a unit of power. A watt is the same as a joule per second, so depending on how long it takes to output a million joules, the power can be very high, or very low.
Yes compared with fossil fueled power plants of the same electric power output.
200 kilowatts is a small amount compared to the reactor's design output, but this would produce about 70 kilowatts of electric power
Yes. Though the response time of a pneumatic system is better as compared to hydraulic, power output is higher in latter.
If the output power is 70% of the input power, then the output is roughly 1.55 dB downcompared to the input.If the voltage at any point of the output waveform is 70% of the voltage at the same pointon the input waveform, and the input and output impedance are equal, then the output is3.1 dB down (rounded) compared to the input.
Yes, the word yesterday is both a noun and an adverb. In the sentence, 'Yesterday, you went power kiting', yesterday is used as an adverb modifying the verb went, 'you went yesterday...'.
If you do work on an object in half the your power output is
Output Power divided by Power Factor.
That is called the efficiency, and it is a number between 0 and 1 (or 0% and 100%). It is obtained by dividing output power / input power.
Transmission line efficiency is power at the recieving-end of the line compared to the power at the sending-end of the line and is expressed as a percentage, so this can be formulated. % efficiency = load power (output) / source power (input) x 100 In the line, there are power losses. to calculate this we use the formula: power loss = 3.I2.R where I is current and R is resistance. Now that we have the losses, we know the difference between the input and the output. So, for example, if one had the output value known, then to get the input we just add the loss to the output or if had the input known, just subtract the loss from it to get the output. hope that helps
The difference is in the output frequency.
A Computer Output Electricity in Computercraft cannot be said to make a program to output power, regardless of the side.
Force affects the speed of power output. If the driving force is slow, the speed of power output will also be sluggish. Alternatively, if the driving force is fast, power output will be able to match the speed.