If the wiring diagram calls for it,yes.
There are many places where one could buy a timer to control a light switch. One looking for a timer to control a light switch should visit popular on the web sources such as Lowe's, Intermatic, and Honeywell Store.
The wattage rating of a timer is governed by the manufactures specification. As long as the light bulbs wattage rating is not higher than the timers rating, the timer will be alright to use in the circuit. The circuits load is what governs the wattage of the circuit.
3 pence an hour
It sounds to me like the exhaust timer is just a switch. The 20 amp rating that the timer is given is the maximum amount of current that it can handle and still be within its safety specifications. It will work very well on a 15 amp circuit.
Not usually, The light would have had to been wired with a three wire from the switch to the fan. One circuit to control the fan and the other switch to control the light. If this is your situation then all you will have to do is change the light switch to a timer and that will do what you want.
A licensed electrician can install a timer on your light.
I need to know if there is a yellow engine light or red engine light. Could it be timer chain or timer belt?
There are many places where one could buy a timer to control a light switch. One looking for a timer to control a light switch should visit popular on the web sources such as Lowe's, Intermatic, and Honeywell Store.
It is acctually a sensor.
LEDs do not work on all timers. This is also the case with many energy saving bulbs. The timer lets enough voltage thru to partially light the LEDs and energy saving bulbs. LEDs will light fully when the timer is "on", but will continue to light dimly when the timer says "off". Energy saving bulbs will have a dim flicker when "off" thru a timer. I have not found a timer yet that solves this problem. If anyone knows of a solution I'd love to be able to use energy efficient lights with the convenience of a timer.
no. you have to take the whole light out
The wattage rating of a timer is governed by the manufactures specification. As long as the light bulbs wattage rating is not higher than the timers rating, the timer will be alright to use in the circuit. The circuits load is what governs the wattage of the circuit.
I'm not gonna answer that. The light from tanning beds is so intense that it can easily cause damage if you overdo it. The timer is set to protect you.
You can either use the inbuild timer in VFD or go with secondary timer or a controller like PLC. You may use the below link to learn more on VFD www-dot-smeclabs-dot-com
Your TV has a problem. If you watch the flashing red light and count the blinks, it's actually flashing a trouble code. Maybe something like four blinks, followed by three and then repeating. The other possibility is that it's in timer mode and the flashing light is reminding you that the timer's been set.
3 pence an hour
Usually there is a knob that clicks when you turn it, as you turn it the light will go on and off.