yes
Wiki User
∙ 13y agoA beaker is used to measure volume using water displacement.
You fill up water ina beaker, measure the volume of the water as it originally was, then drop in an irregulary-shaped object, measure that volume, and subtrect the two. The difference is the volume of the object.
Place it in a graduated cylinder (or any other metered container), completely submerge the object, and record the amount of water displaced. ---------------------------------------------------------------------------------------- Place an empty beaker onto a second larger catch pan. Be sure that your catch pan will hold water without leaking, and make sure it is large enough to catch ALL of the water that will spill out of the beaker. Fill a beaker until you can see the meniscus above the rim of the container. CAREFULLY lower your irregular object into the beaker with water allowing the beaker to over flow into the catch pan. Once you have your object submerged in the beaker, remove the beaker from the catch pan. Let the little bit of water adhered to the exterior of the beaker drip into the catch pan for a few seconds to make your measurement as accurate as possible. Using a graduated cylinder, measure the volume of water that has over flowed into your catch pan. The volume of this water will be very close to the volume of your irregular object.
A graduated cylinder would be the best piece of laboratory equipment to measure a 350 ml of water. It is designed with volume markings and is specifically used for accurate measurements of liquids.
Fill the beaker with water, then pour it into a calibrated measuring jug
A beaker is used to measure volume using water displacement.
To measure volume
It is necessary to know the mass of the empty beaker.
Graduated Cylinder (A+)
It is transititve. For example, I measured the water in the beaker.
Submerge it in water and measure how much the water rises.
Measure the water in a beaker of some sort.
The volume of the water in Beaker X will be 100cm3, as you are not adding any more water to the equation (50X+100Y is not 150Y or X, but 50X+100Y) The total volume of matter in Beaker X will be 150cm3, and if the beaker is labelled, the volume measure will indicate 150cm3 due to the displacement of water. But as the answer to your question, the volume of water in Beaker X must be 100cm3 even though visual indicators will not show this due to the displacement of water by marbles
It's got to do with science
No. I cannot envisage any situation in which someone would want to measure the length of water!
if your in a lab, put water in a beaker, place the beaker on a tripod and heat with Bunsen burner, (use thermometer to measure
a large beaker and sponge