One wire is the hot off the plug, one is the hot to one socket, and the third wire is the hot for the second socket. You'll have to check the switch for the exact color code / which wire is which (I don't know if there is a standard). You can test it easily with a multimeter as well.
eHow is a great resource for topics like this, with articles like "How to Re-Wire a Lamp," "How to Rewire a Lamp with a Rotary Switch," "How to Rewire an Old Lamp," and "How to Wire a Floor Lamp."
By changeover switch, if you mean forward reverse switch, the correct electrical terminology you should be searching is, wiring of an electrical drum switch.
When you switch off a 3-pin power socket, the socket and connected devices are no longer powered, but the socket still remains earthed. The grounding connection provided by the earth pin is separate from the power supply and remains connected even when the socket is switched off.
A three-way lamp switch requires a dedicated three-way bulb and socket to function on all three settings. If used in an outlet controlled by a wall switch, the voltage may not be appropriate for all settings to operate correctly. Additionally, the wiring configuration in the wall switch setup may not be compatible with the three-way lamp switch.
An ordinary light switch does NOT have any neutral -- it only switches the live wire. Some installers use the white wire as a "switched" wire to the light fixture, where the power cable went to the light and a separate cable went to the switch. Technically, the white wire should have been marked with red or black tape at each end, to signify it is not neutral - it is either live or off. In that case, you would not be able to use a PIR switch because there is no neutral, which is necessary to provide power to the electronic circuit in the PIR. You would need to rewire the switch with a new power cable from the branch circuit. The you have the live and neutral wires in the outlet box, connect them to the PIR, and run the pigtailed neutral and the switched live (and pigtailed ground) to the light fixture (where you would disconnect the other power cable completely and cap the ends separately).
eHow is a great resource for topics like this, with articles like "How to Re-Wire a Lamp," "How to Rewire a Lamp with a Rotary Switch," "How to Rewire an Old Lamp," and "How to Wire a Floor Lamp."
A rotary switch.
Type your answer here... Why are you wanting to rewire the brake lights?
You switch the carborator with the ac and then rewire the inside to the dashboard
It enables you to switch off the load from the socket, rather than have to pull the plug out of the socket.
A rotary switch is a switch operated by rotation. These are often chosen when more than 2 positions are needed, such as a three-speed fan or a CB radiowith multiple frequencies of reception or "channels".
First unplug the wire harness from the switch. Using the correct size socket (1" if I remember correctly) remove the switch counterclockwise from the transmission. Install the new one in reverse order.
No This is not easy. It is easier to replace the signal light switch assembly
The steering wheel cannot be bypassed to rewire turn signals in a 1989 Chevy Corsica. The switch for the wires is in the steering column. If the steering wheel were bypassed, the wires would not be connected to the switch.
chiltons manual has wiring diagrams for that
By changeover switch, if you mean forward reverse switch, the correct electrical terminology you should be searching is, wiring of an electrical drum switch.
turn the switch on the socket on :-D