the answer is dc volts are rectified from ac volts and the amperage will be the same unless you account for the slight drop from the rectifier. dc volts from a battery have no relationship to ac volts. you can derive ac volts from a dc source using an inverter.
No, Ohms Law applies equally well in ac as in dc.
They allow the user to test: Volts (AC and DC), Amps, Ohms and basic continuity.
Amps is amps be it DC or AC.
It measures potential difference, current, and resistance (volts, amps, and ohms), in several AC and DC ranges.
Volts don't make power. Watts do. Watts = (volts) x (amps) 1 horsepower = 746 watts (Doesn't matter if the source is AC, DC, or a combination of both.)
12 Amps x 12 volts = 1200 watts 1200 watts / by 120 volts = 10 amps at 120 volts Answer is 10 amp hours
The danger is in the voltage, not if it is ac or dc. For instance, 12v dc or 12v ac makes no difference in body contact. Neither will shock you. Usually 24 volts will not shock either. When you get to 48 volts or greater, then you have a chance of shock. 100 volts Ac or Dc shocks basically the same. 120 volts AC is actually 144 volts peak to peak, so 120 volts AC is slightly worse than 120 volts DC. Amperage is actually what kills. A "Taser" voltage can be as high as 50,000 V but the amps are so slow that it doesn't do permanent damage. Commonly people are shocked accidentally by a spark plug wire on a car or a lawnmower with no lasting or ill effects. This voltage can range from 15,000 volts to more than 50,000. These systems have very low amperage.
A: It is a regular DC voltmeter but the AC is rectified and the DC component is measured and displayed as AC VOLTS.
1 HP is 746 watts in principle. The power is in watts, and the power is the volts times the amps. For an AC motor the power is the volts times the amps times the power factor times a factor that depends on the power-conversion efficiency of the motor.
With an instrument called a multimeter. The single meter incorporates within it a volt meter, an ohm meter and an amp meter. For higher amperages a clamp on amp meter is recommended as the circuit does not have to be opened to take a reading.
Watts are amps x volts, so w/o the volts the question can't be answered. At 100 volts it'd be 15 amps.
DC