0
time delay will be 1/RC x 5 where R = value of resistor in ohms C= capacitance in Farads time delay will be 1/RC x 5 where R = value of resistor in ohms C= capacitance in Farads time delay will be 1/RC x 5 where R = value of resistor in ohms C= capacitance in Farads
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Time constant of an RC circuit increases if the value of the resistance?
Increased The time constant of an "RC" circuit IS RC. So it's directly proportional to 'R' and also directly proportional to 'C'.
An RC circuit has a time constant of 3.6s and is fully charged to 21V and if it is in a dischange mode how long until capcaitor is discharged?
An RC circuit with a time constant of 3.6s will take 5 time constants, or about 18 seconds to fully discharge a capcaitor.Theoretically, the capacitor will never discharge, because an RC circuit is logarithmic, but 5 time constants is the generally accepted time to discharge to less than 1% of initial voltage.
What happens if capacitance is increased in parallel RC ciRCuit and series RC ciRCuit?
In both cases, the time constant of the RC circuit is increased. If the application is a high- or low-pass circuit, then the filter cutoff frequency is decreased in both cases. If the application is a phase-shift network, then the frequency for a given phase- shift is reduced.
Time constant of an RC circuit increases if the value of the resistance is?
Answer : increase The time required to charge a capacitor to 63 percent (actually 63.2 percent) of full charge or to discharge it to 37 percent (actually 36.8 percent) of its initial voltage is known as the TIME CONSTANT (TC) of the circuit. Figure 3-11. - RC time constant. The value of the time constant in seconds is equal to the product of the circuit resistance in ohms and the circuit capacitance in farads. The value of one time constant is expressed mathematically as t = RC.
What is RC time constant of differentiating circuit?
It's the product of ' R ' times ' C '.
What is the value of a circuit with a 20k ohm resistor and a 0.5 micro farad capacitor?
The time constant of an RC circuit with a 20 K ohm resistor and a 0.5 uF capacitor is 10 mS. (0.02 M Ohm times 0.5 uF) A time constant of 10 mS means that a step change in input voltage would take 10 mS to reach about 0.63 of the output voltage. Its an exponential thing, with the equation being...VT = V0 (1 - e(-T/RC))...depending on how the components are arranged..The value of such a circuit is that you can use it in various filter, time delay, or oscillator circuits.
How do you debounce a switch?
In a digital circuit probably the best way is with a monostable multivibrator, or one shot timer. The length of the timer should be made to be just a little longer than the bounce time of the switch. Ans2: My favourite is a 2 input NAND gate with both inputs connected to the switch, but with a small RC delay circuit in one of them.
What happens to the total impedance of a series RC ciRCuit as the frequency is increased?
when the frequency is increased the total impedance of a series RC circuit is decrease.
What type of circuit is it when capacitors are combined with resistors?
RC Circuit
An RC circuit has a time constant of 10ms and an applied voltage of 15V What is the voltage on the capacitor after one time constant?
About 5.5 volts.
Explain about the effect of the time constant RC in envelope detector?
The circuit that generates signal having the shape like imaginary curve is called an envelope detector. The effect of the time constant RC in envelope detector is that the output follows the input curve and the circuit performs like a demodulator.
What is the difference between LC and RC filters?
LC means coil capacitance circuit RC means resistance capacitance circuit
