Bulk density = dry weight / volume, then by knowing the dry weight and bulk density we can calculate the volume.
It depends upon the volume of the bulk bag and how deep you want it covered. Divide the cubic meters in the bulk bag by the depth in meters to get your answer. For example, a bulk bag of 2 cubic meters will cover to a depth of 1 cm. 2 cubic meters / 0.01 meters depth = 200 square meters.
It depends on the density of the sand. Certainly, you are talking about 56 cubic feet, but you will need to know the bulk density of sand to figure out how much that weighs.
The crushed can will have a density that is quite a bit higher than the density of the can before it was crushed. Imagine a box of empty aluminum beverage cans. It won't weigh much. If those same cans are crushed, they will weigh the same, but take up a lot less space. The density of the cans can be increased by crushing them. The cans might be said to have a low bulk density before being crushed.
The velocity of pressure and shear waves through a solid is dependent on the elastic properties and density of the material through which the wave is travelling.The pressure wave velocity (VP) can be found using the following:VP = Sqrt((K+ (4/3 x G)) /P)Where:K = Bulk modulusG = Shear modulusP = DensityThe shear wave velocity is given by the following:VS = Sqrt (G/P)Where:VS = Shear wave velocityG = Shear modulusP = Density
No. Corn Flour has a bulk density of 0.82 g/ml which means that 5g of corn flour is 6.1 ml and 5 ml is 4.1g.
Calculate volume of molecule, calculate mass of molecule, compare to bulk density. Lower bulk density indicates empty space.
You're almost certainly asking about bulk density. I hear it mispronounced as "bunk" density daily. Bulk density is how much mass of a substance will fit into a given volume without any packing. It tells you about the particle density and also the packing order.
You don't
Based upon bulk density
Mass divided by volume. Weigh the pellets to find the mass, then add the pellets to a measuring cylinder of water (or something of higher density than your pellets) and find the volume using the rise of water in the measuring cylinder
"Tapping" is a procedure in which a powder is placed into a graduated cylinder which is then tapped to compress the sample before its volume is measured. This reduces the amount of air trapped in the material. "Theoretical" is a method of determining the density of a mineral from the volume of a single cell.
Bulk density is the dry mass of the solids (M sub t) / total volume (V sub t) Particle density is bulk density (P sub b) / 1 minus total porosity (1-theta).
Bulk density is defined as the weight per unit volume of material. Bulk density is primarily used for powders or pellets. The test can provide a gross measure of particle size and dispersion which can affect material flow consistency and reflect packaging quantity. Bulk Density ASTM D 1895 B
Concerning the second Question: "Can you find bulk density with just this info?"Purely on mathematical insight and analysis:Yes, you should be able to find the bulk density of dry soil, given the 'dry overall' and the 'particle' densities.When wet, there is not enough 'given'Also some should be known about the (or your) definition of porosity
First find the bulk density of coal as per the respective grade. then multiply density with volume you will get mass
Bulk density is a mainly a property of powders, granules and other separated solids, usually used in minerals like soil or gravel. It is defined as the total amount of particles over the total volume they occupy.
bulk density depend on that material from which soil formed. so maximum bulk density depend on particle density of that mineral. Therefore,we can only tapped the soil upto perticle density. so maximum bulk density may be occur at equal to paricle density.