The new cooktop has a 4 wire connection. Red & Black are hot. White is neutral, and green is ground. You existing panel is wired with 3 wires. Black & Red are hot and green is ground. There is no neutral wire. Connect the black to black, red to red, and then connect the white and ground together at the plug.
If your electrical service is only 120 volts you have a problem. There is no way that you can connect a 240 volt cook top to that service. You have two options, one is to upgrade to a new 120/240 volt electrical service. Your other option is to find a 120 volt electrical cook top.
Two wires can be connected to one main lug in a panel board if the lug is designed to hold two wires. The data will be written on the lug.
I assume you mean you are wiring a 220 volt circuit. You will install a 220 volt double pole breaker of the correct size for the circuit. An example would be for an electric dryer that requires a 30 amp double pole breaker wired with 10/3 wire. You connect the Red & Black wires to the breaker. One on each screw. You now connect the White wire to the neutral bus bar in the service panel. Then connect the bare copper ground wire to the ground bus bar in the service panel. At the dryer outlet connect the black & red to the hot screws, white to the neutral, and ground to ground. They will be labeled on the back of the outlet.
they can be any color except for white, gray or green.
Your ballast should show two wires for supply side of ballast. Make sure that neither side of this is grounded to the light and connect the 220 V from your breaker to these two wires and then connect a ground to the chassis of the light from the panel.
If your electrical service is only 120 volts you have a problem. There is no way that you can connect a 240 volt cook top to that service. You have two options, one is to upgrade to a new 120/240 volt electrical service. Your other option is to find a 120 volt electrical cook top.
take a solar panel & add wires on the panel & connect these wires to the small appliance!!!!
Two wires can be connected to one main lug in a panel board if the lug is designed to hold two wires. The data will be written on the lug.
yes wires is electrical panel
I assume you mean you are wiring a 220 volt circuit. You will install a 220 volt double pole breaker of the correct size for the circuit. An example would be for an electric dryer that requires a 30 amp double pole breaker wired with 10/3 wire. You connect the Red & Black wires to the breaker. One on each screw. You now connect the White wire to the neutral bus bar in the service panel. Then connect the bare copper ground wire to the ground bus bar in the service panel. At the dryer outlet connect the black & red to the hot screws, white to the neutral, and ground to ground. They will be labeled on the back of the outlet.
No, not unless your connect the plug wires wrong or one of the new spark plugs was bad.
In the heater you will have two wires. You should then have 2 supply wires from the panel, and 2 wires from the thermostat. The neutral (white) supply wire should go to one of the wires on the heater. The hot (black) supply wire should connect to one wire from the thermostat. The other wire from the thermostat will connect to the other wire from the heater.
they can be any color except for white, gray or green.
Your ballast should show two wires for supply side of ballast. Make sure that neither side of this is grounded to the light and connect the 220 V from your breaker to these two wires and then connect a ground to the chassis of the light from the panel.
plug them in
plug them in
Answer why does the person who made a circuit a probably connect the wires to a penny