How do you convert fractions to what?
18cm convert into mm
to convert means to change
That depends what you want to convert it to.That depends what you want to convert it to.That depends what you want to convert it to.That depends what you want to convert it to.
To convert inches to centimeters, multiply by 2.54. To convert from centimeters to inches, divide by the same factor.To convert inches to centimeters, multiply by 2.54. To convert from centimeters to inches, divide by the same factor.To convert inches to centimeters, multiply by 2.54. To convert from centimeters to inches, divide by the same factor.To convert inches to centimeters, multiply by 2.54. To convert from centimeters to inches, divide by the same factor.
24VAC used to make dual band 12VAC eg. AC sign wave. one is negative goes up, one is positive goes down. polarities switch and frequency is made and can be tuned. Commercial application: Lots of medical equipment. Seismagraphs.
yes it is compatible to use 24VAC to 24V supply
24 volts of alternating current
A control transformer marked 240V - 24Vac would have a control voltage of 24 volts.
No, you cannot.
4.8va/24v = 0.2a
no, in an ac circuit the coil provides impedance but the DC coil needs some resistance to limit the current
I can say that 24VAC means 24 volts alternating current. 24VDC @ 1A means 24 volts direct current delivered at 1 ampere. So the difference I suppose would be: 1. Alternating current VS. Direct current 2. X Amperes(VAC) VS. 1 Ampere (VDC)
Yes, 12 v 5 a is 60 va, and it does not matter if it is ac or dc voltage.
In 50 VA the V stands for volts and the A is for amps. Hence the formula you are looking for is 50/240 = Amps.
There is insufficient information in the question to answer it. You need some other information, such as voltage to current phase angle, inductance, capacitance, or watts. Please restate the question.
Twelve volts is not a common three phase voltage. Assuming that this is a hypothetical question any 1:2 ratio transformer will do the job. Rather common for electric fork lifts very small ones use 12v (hand stackers,pallet jacks) larger ones are 24v 36v or 48v the original transformers on the chargers usually run from 480V and the chargers are specifically designed for the battery most chargers use half wave rectifiers in a star configuration 600A thru a .7v drop for a diode is 500w loss, full wave is 1000w regulation is switched from the primary side since its easier to handle the low current