If it is in a location where it needs to look neat then you have to redo the box. This involves some carpentry or sheetrock work along with possible rewiring skills. If you don't care how it looks just put on a normal switch plate. However, this is sloppy work and shouldn't be tolerated if you have any recourse with the person who did the work.
Wires are not to be spliced or otherwise connected except in an approved electrical box. The box should be accessible, such as an electric outlet or switch box. If you decide to NOT use the box as an outlet or switch box, make certain that you use a blank cover.
A gang switch is an electrical box that contains two or more switches or outlets. Gang switches are very common in public facilities such as schools and hospitals. A two gang switch would be two switches operating different fixtures sharing the same electrical box.
Answer for USA, Canada and countries running a 60 Hz supply service.Yes you can, but the light will only come on when the fan is operating. If there is a three wire going up to the fan from the light switch box then it was pre-wired so that a separate run for a light to be operated independent from the fan. The cable will be a red, black and white wire. The black will connect to the fan, the red to the light in the fan and the white to both the neutrals of the fan and light which is up in the fan housing.If the switch box is only a single gang box there is a duplex switch that can be installed in the box. The cover for this duplex switch is the same cover as a duplex receptacle cover.
There has to be more to this question for a good answer. For the most part a light switch has two contacts, with a wire at each one. One live wire and another going to the light itself. There is also a neutral wire return (from the light to the electrical panel). There is only one live wire in any electrical circuit. [Please, don't flame me with examples of multiple electrical sources in circuitry. We're talking about home lighting.] If somehow you shorted the live wire from the switch to the electrical box (ground) or to another wire in the box, it was only momentary and you can just proceed with replacing the switch. It's a good idea to turn off the power first.
Generally the fuse box is housed in the house electrical switch board located on the outer wall of the house. Since the switchboard also houses the supply authority meter to record electrical use, the supply authorith needs access to the meter in the switch board. Accordingly the supply authority will only allow the use of a lock to which they have a master key. Usually the supply authority will supply a lock (At a small cost) with which to lock the switch board
Wires are not to be spliced or otherwise connected except in an approved electrical box. The box should be accessible, such as an electric outlet or switch box. If you decide to NOT use the box as an outlet or switch box, make certain that you use a blank cover.
Answer varies. Is it a deep or shallow box? is there a receptical, a switch in the box as well? is it just a junction box? are they single wires or NM cable?
An electrical supply must be accessed and a wire fished to the fixture box. Do not attempt unless you are knowledgeable in electrical matters.
Switch off the box at the mains, remove the (dead?) wasps with a small paint brush, turn the box back on afterwards.
The 1993 Honda Civic fuel reset switch is located in the fuse box. The location of the fuel reset switch will be listed on the inside cover of the fuse box.
The 1991 Acura Integra fuel cutoff switch can be found in the fuse box. The fuse box is in the engine compartment. The cutoff switch location can be found on the inside cover of the fuse box.
The Chevrolet Silverado 1500 fuel pump shutoff switch is located in the fuse box. The location of the switch can be found on the inside cover of the fuse box.
Yes, you should turn it off.
You can find the starter relay switch in the fuse box. The starter relay switch will be one of the relay switch is in the third column. The exact location should be listed on the inside cover of the fuse box.
There isn't a "fan motor switch", but there is a fan motor relay, located in the electrical box under the hood by the engine.
There is no fuel reset switch. There is a fuel pump fuse within the fuse box and there is a relay inside of the electrical panel in the engine compartment, but there is no reset switch.
you get a box cover it with clay and get popscicle sticks for ladders connecting to the second floor of the box and makea field with green felt at the bootom of your display that is what i am doing