0
What else can I help you with?
How do you measure diameter?
Internal diameter.
How does he find the measure of a radius if he knows the measure of the diameter?
The radius of a circle is half the diameter.
How do you find taper angle?
The taper angle is the angle where a thread is tapered as it is created. The formula to find it is to subtract the small diameter from the large diameter and multiply by 28, then divide by the length of the taper.
What is the diameter of a goal hole?
4.25 inches
What is radius of a 40 diameter hole?
the answer is 20
Is the golf hole tapered to a smaller diameter at the bottom?
The diameter of the "cup" is the same top to bottom. There is, however, a slight beveled edge which makes the ball sit in the middle of the cup making it easier to retrieve by the golfer.
What is a slightly tapered thread that is characteristic of a tap.?
It has got to be tapered to get in a fresh hole. Then you can finish it up with a square one to tap out the bottom of the hole.
What is a slightly tapered thread that is characteristic of a tap?
It has got to be tapered to get in a fresh hole. Then you can finish it up with a square one to tap out the bottom of the hole.
How can one accurately measure a hub?
To accurately measure a hub, use a ruler or caliper to measure the diameter of the hub's center hole. Then, measure the distance from the center hole to the outer edge of the hub to determine the radius. Multiply the radius by 2 to find the diameter of the hub. Make sure to measure carefully and accurately for precise results.
Why is cotter pin tapered on one side?
To easily start it in the hole.
What is the stock subwoofer size in a Oldsmobile aurora?
measure the diameter of the hole for the speaker/subwoofer and the distance to each bolt hole to asure you get the right subwoofer to fit properly.
What is the length of a black hole?
Black holes do not have a physical surface or boundary to measure the length. The size of a black hole is typically defined by its event horizon, which is the point of no return beyond which nothing, not even light, can escape the gravitational pull of the black hole.
Is the pittman arm a unwearable part?
One end of the pitman arm connects firmly to the steering gear on a spline. No moving or wearing parts on that end. The other end of the pitman arm has a tapered hole. The steering linkage connects to the tapered hole with a tapered ball joint fitting. If it isn't damaged, a pitman arm will not wear out.
What was Gene Sarazens suggestion to increase the diameter of the hole for golf?
4.24563 inches is the diameter of a golf hole.
What does the diameter of a golf hole measure in inches?
4.25 inches is the current size of a golf hole
How do you measure lug patterns?
On a five bolt pattern measure from outer edge of one bolt then across to the middle of another skipping one bolt hole( not quite the diameter). On six or four bolt patterns measure across from bolt center to bolt center as you would the diameter if it were a circle.
How do you measure diameter?
Internal diameter.
