The Autocad standard of the first line of dimensions is typically 3/8" off the object. With the baseline spacing from that set to 1/4".
Only if you know your location (the coordinate on the distance scale and the time scale) where "you" are can you infer if the object is moving towards you (the absolute distance to the object is decreasing) or away from you (the distance is increasing).
If you are d metres away from the base of an object, and the top of the object is at an angle x from the horizontal, then the height of that object is given by:h = d*tan(x).If you want to be more accurate, or if x is small, you should add the height of your eyes from the ground to the answer obtained from the above formula..
It means that the object is close or not too far away.
a quarter
15 meters north. the object is only moving away from the original starting place. its not like its moving away and then back again.
increased
That completely depends on how far away the object is. The entire sun can be covered up by a smaller object that's closer to you, like the moon, or the end of your thumb.
One dimension away.
"Go away" does not have a direct object. "Go" is a verb, and "away" is an adverb.
When a force is applied to an object, it accelerates. for example, if you push an object, the object accelerates away from you and, eventually, will move away from you..
Run away!!!!
It shows bias but they can get away with it if you have a record, if not, your attorney should object.
Answera 3d drawing with dimensions...or a series of 2d drawings with dimensions, sections, and plan views.Usually the type of 3d drawing is an isometric - coming from Greek Isos ("equal") and metric ("measure"). In an isometric drawing, the object's horizontal lines are drawn 30 degrees to the horizontal, and all co-planar, co-directional lines are drawn parallel (as opposed to perspective drawings in which an object appears to get smaller the farther away from you it gets). The dimensions are just enough to adequately recreate the object, none missing to leave room for guessing.Dimensions are made up of extension lines and dimension lines. The extension lines extend from the object, usually starting 1/16" or so from the edge of the object itself. The dimension lines have any of a number of types of arrowheads and are drawn between the extension lines, usually with the dimension centered within the dimension line.
Why is this under snakes and to answer your question, lock it up with a lock even a simple lock can stall him long enough for you to react.
the starship's momentum moved it away from the wormhole to the evil dimension
Up, up, and away.......like in the song from the 5th Dimension.
The give-away should be the word "length" which is hidden in the word "wavelength". Wavelength has the dimensions of length, and is most often stated in meters or centimeters (radio), nanometers (light), etc.