5 feet
There should be a switch on the light itself to disconnect the sensor.
The backup light switch is located on the left side of the transmission. Disconnect the switch connectors, then unscrew the switch.
The exterior lights do not have a relay. They are directly turned on by the headlight switch.
Push the rear window defrost button , located with your heater controls , that also heats your exterior mirrors
Removal and Installation Remove the trim panel. Release the clip. Release the locating tabs. Remove the trim panel. Disconnect the exterior mirror control switch electrical connector. Disconnect the exterior mirror electrical connector. Release the clip. Release the electrical connector. Disconnect the electrical connector. Remove the exterior mirror. Remove the bolt. If equipped, remove the screw. To install, reverse the removal procedure.
The neutral safety switch is located on the side of the transmission at the linkage connection. Unhook the wiring connector, Disconnect the linkage, then unbolt the switch to replace it.
R65 Type transmission Disconnect battery. To improve access to switch you could remove the air cleaner. Disconnect the the wiring connector to the switch which is located on the side of the gearbox. Unscrew the switch and remove. Refitting is the reverse of above but a new sealing ring shoukd be fitted. PG 1 Type transmission As above for battery. Jack up car, switch is on top of the gearbox. May need to remove the under shield to get at the switch. trace the wiring back from the switch until you come to a connector and disconnect. Refitting is reverse of above but a new seal should be used.
An EXO switch stands for EXternally Operated disconnect switch.
An EXO switch stands for EXternally Operated disconnect switch.
If it is a dash warning light, there is a failure causing it. If it is an exterior light, the switch may be on.If it is a dash warning light, there is a failure causing it. If it is an exterior light, the switch may be on.
If the porch light switch is the only outside item controlled y the switch bank inside the house, the porch light switch should be located the furthest from the door frame adjacent to which the switch bank is sited. The switch closest to the door should control the lighting in the room immediately adjacent to the door. In this manner, when entering the room from the outside in the dark, you merely toggle the nearest switch to the door frame to light the room - you don't have to reach around or over other switches. Switches controlling other internal lights should be sited in between. So, for a 2-gang arrangement, the switch located closest to the door frame controls the interior light and the other switch controls the porch light. For a three-gang arrangement, the middle switch would control another interior light. The only complication is that is if there are switches in the switch bank that control other exterior circuits, the porch light would be inboard of these and would not be the last outboard switch in the array. So, for a three-gang array in which two exterior lights are switched, the porch light switch would be the middle switch and the other exterior lights (sports, floods, landscape lighting, etc.) would be controlled by switches placed further from the door frame.
Disconnect the battery, reconnect and try it.