There is no standard. Any distance will do.
As close as you want. You must insall an outlet a minium of every 12 feet of wall space. If the wall is smaller that 24" it does not require an outlet.
Your toilet should be roughed in from finished wall to centre of outlet flange at 12 inches. This will keep the tank on most models about one inch from the wall.
It's probably more difficult than you might expect. I'm assuming you have a NEMA 5-15R outlet, and you want to plug in a dryer that has a NEMA 14-30P plug at the end of its electric cable. The NEMA 5-15R outlet is by far the most common type of outlet in North America. It has two flat slots (hot and neutral), and a round safety ground hole. It is rated for 15 A and 125 V. On the other hand, most electric clothes dryers have an electric cable with a NEMA 14-30P plug on the end. It has two flat slots (2 hots from 2 different phases, each one 120 V from neutral, and each one rated at 30 A), an L slot (neutral), and a round safety plug. It is possible for an electrician to "fish" a electric cable carrying the necessary phases through the wall from the fuse box to that outlet, and then pull the old outlet and install a new outlet. If one merely did that last part -- pulled the old outlet and placed a new outlet -- without the proper electrical cables in the wall behind it, then the dryer would probably blow the fuse at the fusebox every time it was turned on.
You can put them as close together as you want but you must have 1 outlet a minimum of every 12 feet. Doorways do not count. If there is a wall that is 2' or more it must have an outlet.
In the far north of England - not too far from Hadrian's Wall or Scotland. Up the A1 road as far as 'Scotch Corner' then travel north-west. So not as far north as Newcastle.
There is no specific code rule that governs the distance between the two components.
It doesn't matter just make sure that the receptacle is of a GFCI type.
A gas dryer burns gas to provide the heat needed to dry clothes. As it only needs a relatively small amount of electrical power to drive its motor, and maybe also a timer, the electrical socket outlet which a gas dryer plugs into need not be much different to a normal wall socket outlet. Any electric dryer uses a high-power electric heater, which takes a lot more current than is available from a normal socket outlet, so a special dryer socket outlet is needed to power an electric dryer safely.As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed.Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized.IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
The fuse box in the 1977 corvette is on the outside wall under the dash on the drivers side - about as far up in the corner as they could put it.
Florida is in the Southeastern corner of the United States.
6 feet
Arkansas