0
100,000,000,000
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
How many square feet will a ton of salt cover?
How many square feet will a ton of salt cover?
How many square feet are in one ton of steel?
221
Convert one ton to square feet?
One ton is a unit of weight. Square Feet is a unit of space. You cannot convert the two without knowing more information such as a tone of what will cover such and such square feet, a ton of insulation will cover this much square feet to this depth. etc...
How many square feet will a ton of gravel cover?
Based on sand and gravel calculator found on L.R. Faulk Construction Co. site, 1 ton of gravel (clean rock) will equal approximately 7.3 sq. ft x 6 inches deep, or 5.2 sq. ft x 3 inches deep. A ton of gravel will cover approximately 15 square yards (135 square feet) at 3 inches deep.
How may square feet does a ton of gravel cover?
That depends on the size of the gravel and how thick a layer you want to end up with.
How do you work out how many squared meters a ton of sand will cover?
one ton of sand covers about 100 square feet which is about 9.3 square meters.
Square feet in a ton of sand?
The answer will depend on how thinly the sand is spread.
How many square feet will a ton of salt cover?
How many square feet will a ton of salt cover?
How many square feet are in one ton of steel?
221
About how much does a ton of sand cost?
depends on what kind of sand you want. Prices can vary from $15 to $30.
How many cubic feet in one ton of m sand?
Masonry sand is estimated to weigh approximately 160 pounds per cubic foot. Therefore, it would take 12.5 cubic feet of masonry sand to equal one ton.
How do you calculate the amount of sand needed to cover 100 square feet 2 inches deep?
Sand is usually sold by the ton so if you find the amount needed by 100 x 1/6 this will give you your cubic foot total. Then you will divide by 27 which is the number of cubic feet in a cubic yard. You should have 16 cubic feet at these measurements. 16 divided by 27 is .59 or a little over half a cubic yard. There are 22 cubic feet of sand per ton so 1 ton of sand should do it. So if the sand in your area is sold by the ton then get 1 ton. If it sold by the yard get 3/4 yard if you can. Hope this helps.
254 square ft with 2 inches of sand how much sand do you need?
about 4.8 ton of sand
How many square feet are in one ton of livestock grain?
The square feet is a unit of area.The ton is a unit of mass, so the conversion is impossible.
How many square feet will a 4 ton air conditioning unit cool?
One ton of air conditioning can cool approximately 600 square feet of area, if the climate is not too hot and humid. Using that formula, a four-ton air conditioner can cool about 1600 square feet of area.
Btu needed for 1800 square feet?
There are many factors that need to be taking into your question. Such as insulation factor, how many exterior walls, demographics... Typically 1 ton of an air conditioner will remove heat from 500 square feet. 1800 square feet will need a 3.6 ton unit but they only make air units in half ton increments. You will need a 4 ton unit.
Convert one ton to square feet?
One ton is a unit of weight. Square Feet is a unit of space. You cannot convert the two without knowing more information such as a tone of what will cover such and such square feet, a ton of insulation will cover this much square feet to this depth. etc...
