8.33 gm/cm³
8g per cm3
The "gram" is a unit of mass. Different substances pack more or less massinto the same volume ... the characteristic expressed by their "density".So the volume of 90g depends on what substance you have 90g of.-- 90g of air, or any other gas, at low pressure, could fill the Superdome.-- 90g of water comes up to about 3.2 fluid ounces in a measuring cup.-- But even that is about 19 times the volume of 90g of gold.
Well, 1 liter of WATER (note the density of a substance depends upon which substance it is) weighs 1000g since 1 liter is 1000 milliliters and the density (I hope you realize you can get the mass of a substance from its volume and vice versa by means of its density) of water is 1 gram per milliliter. So 240 liters would weigh 240,000g (or 2.4x10^5g), and since 1000g weighs 2.204622622 lbs, 240,000g would weigh 529.12lbs. I hope this has been helpful in solving this very simple unit conversion (see factor label method, dimensional analysis, and creation of good conversion factors). P.S. my god READ any science textbook
According to the engineering toolbox website ( http://www.engineeringtoolbox.com/water-specific-volume-weight-d_661.html ) at 32 degrees Fahrenheit the weight/density measurement is 62.41 lb/ft3 at 240 degrees Fahrenheit it reduces to 59.08 lb/ft3
Volume of a 240 foot long 1 inch internal diameter pipe is pi x 240 feet x 1/24 feet x 1/24 feet = approximately 1.31 cubic feet (about 2263 cubic inches).
240 milliliters is about one (1.0144) cup (US).
Well, density is a ratio. Therefore the density of the material would be 1g/mL .
density = mass / volume Given mass = 240 g = 240*10^-3 kg volume = 200 mL = 200*10^-6 m^3 Hence density = 1.2*10^3 kg/m^3 Or 1200 kg/m^3
density = mass / volume Given mass = 240 g = 240*10^-3 kg volume = 200 mL = 200*10^-6 m^3 Hence density = 1.2*10^3 kg/m^3 Or 1200 kg/m^3
D=M/V D=240/200 D=1.2 you should include units though. I'm not sure what units you used, which is why i didn't write them.
The population density of Vlekkem is 240 people per square kilometer.
The population density of Nawabshah is 240 people per square kilometer.
The population density of Kutysche is 240 people per square kilometer.
Volume of solution=V=240ml . Density of solution=d=1.13g/ml. Mass of solution=V*d=240*1.13=271.2g . Mass of solute=1.20g . PERCANTAGE W/W = 1.20/271.2*100=0.44%
If you're dealing with water, then 240. You are asking how much weight equals a certain volume. Hard to answer without knowing the density of the substance.
Volume = 753.98224m3
1000 millilitres = 1 litre so 240 ml = 240/1000 = 0.24 litres. Simple!
Volume = 240*40*1 cubic centimetres = 9600 cc = 9.6 Litres