You can do it, on the four prong plug you have 2-hot(120v+120v=240v) 1-neutral 1-ground, on a 3-prong plug you have 2-hot and 1-neutral but no ground. on old electrical systems the neutral and ground bar were wired together. and that system worked fine,now they are isolated. There are no adaptors to do this you will have to change the oven pigtail with a four prong one and use 2-hots(black and red wires) and connect the neutral (white wire) to the green ground wire and attach the green wire to the metal body of the stove or change wall outlet to a four prong (although this is not recomended) you'll have to see if your panel has a isolated neutral bar. Best left to the pros as one wrong touch will give you a one way trip to the pearly gates. Hope this helps. p.s. I've found most ovens will have instructions on how to connect ether pigtail to it ,if its old hop on the net go to mfg.website put in model # usually there are installation manuals avalable.
Go to a home supply store like Home Depot and buy a converter. If they dont have one they can help you fimd someone that does. or call an electrician
If you are in north America, black and red go to the main prongs and white to the ground (round prong) . Black and red can be on either main prong.
My question is WHY did you replace a four prong dryer plug with a three prong! 220 volt Electric dryers require two hot legs, a neutral and a system ground wire. Sounds as though you shunted one of the hots or the neutral. You need to install a four prong plug of the same configuration and wire it exactly as the original.
If you are lucky the fuse will blow. If not the refrigerator might catch fire.
You sure can. It will run a little faster.
A 220 volt treadmill will not run on 110 volt power. if you would wire it to plug in, the low voltage would causes the treadmill to burn up. You will need to install a 220 volt receptacle for it to plug into and work properly. <<>> In the above answer the treadmill will not burn up but at these amperages it will make a very big flash if it shorted out. Also it must be some treadmill to draw 220 amps and I have never seen a 110 amp wall socket.
220 volt electricity 3 prong plug.
If you are in north America, black and red go to the main prongs and white to the ground (round prong) . Black and red can be on either main prong.
My question is WHY did you replace a four prong dryer plug with a three prong! 220 volt Electric dryers require two hot legs, a neutral and a system ground wire. Sounds as though you shunted one of the hots or the neutral. You need to install a four prong plug of the same configuration and wire it exactly as the original.
no
Yes.
A 220 volt power cord has 2 positive terminals. The will look the same. The one that is different will be the ground.
220 volts. In the US.
The bulb will be about half as bright.
Yes
There is no remedy but to plug it into a 230 circut.
On a 240 volt outlet, such as a dryer outlet: G is Ground, W is Neutral, X and Y are the two Hot legs.
If you are lucky the fuse will blow. If not the refrigerator might catch fire.