Sure, as long as it is not exposed to direct contact with water (the phrasing of your question is confusing). You should have a GFCI (Ground Fault Circuit Interupt) outlet in this wet location. Its purpose is to protect the user of an electrical appliance from electrocution. It is highly sensitive to moisture intrusion into the circuit, which causes it to trip.
Yes, it can also cross through a two handled faucet. Both the hot and cold sides of the faucet must be on and the flow of water must be stopped or greatly reduced on the outlet side of the faucet. This can occur when a hose with a spray nozzle is attached to a laundry tub faucet with the faucet on and the spray nozzle off, or when a shower faucet is on but the shower spray head is off. When another cold water outlet in the system is turned on then the pressure on the cold side of the laundry tub or shower faucet in question could be lowered below the pressure on the hot side and hot water can flow into the cold water side. There are faucets which have integral check valves which prevent this from occurring. WWW.WOODBRIDGEPLUMBING.COM
2,5m
Could be bad washers and they need to be replaced or something broke in the handle of the faucet.
Do you have hot water at other fixtures in the house? If not you have a water heater problem. If yes the Shower valve needs to be rebuilt if it is a bressure balanced faucet the concentration should be on the pressure balancing spool area of the faucet.
Do you mean water leak or water pressure at the faucet? If you are not getting water thru the pipes you may have low pressure, or there is some blockage in the pipes preventing the water from flowing. Lots of times dirt gets in the small holes in the shower head and the sinks faucet (right where the water comes out). You will need to turn the water off in the basin or the shower. Next, take a pair of pliers and remove the shower head, or the basin's spout head. Look in the piece you removed. Is there dirt in it? Clean it or replace the part. Turn the water back on. Hopefully it was only debris blocking your water flow. The entire faucet will not have to be removed. Only unscrew the spout's aerator head., or the showere head.
By opening the walls
form_title= Shower Faucet form_header= Install the shower faucet you want in your bathroom! Do you have a working faucet in your bathroom?*= () Yes () No () Not Sure What type of faucet do you want installed?*= _ [50] Do you want the shower faucet to include a massager?*= () Yes () No () Not Sure
Yes, it can also cross through a two handled faucet. Both the hot and cold sides of the faucet must be on and the flow of water must be stopped or greatly reduced on the outlet side of the faucet. This can occur when a hose with a spray nozzle is attached to a laundry tub faucet with the faucet on and the spray nozzle off, or when a shower faucet is on but the shower spray head is off. When another cold water outlet in the system is turned on then the pressure on the cold side of the laundry tub or shower faucet in question could be lowered below the pressure on the hot side and hot water can flow into the cold water side. There are faucets which have integral check valves which prevent this from occurring. WWW.WOODBRIDGEPLUMBING.COM
You have a leak between the diverter and showerhead or the arm for the showerhead is not sealed properly into the fitting in the wall
Yes
yes
YES
Proably the faucet has a worn out washer, replacing the washer should fix the problem.
If it is leaking from the control, you should be able to access that from the front. If it is the supply lines or the pipe to the shower head, there may be access behind it in a closet. If not, you just have to cut a hole to get to it.
All types of showers can function with a bronze shower faucet. Just make sure that when installing the faucet, that you caulk all joints properly to prevent leakage.
No conversion, it would need to be replaced with a single handle faucet.
Usually 48" off bottom of shower floor to center of shower faucet.