0
Substance x has a mass of 6.0g and a volume 3.2ml what is the density of this substance?
Wiki User
∙ 13y ago
The density of Substance X is 1.875 g/mL
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
How many cubic cm in 32ml?
32mL = 32 cubic cm (cc)
What is the volume of an irregular object that displaces 32ml of water in a graduated cylinder?
If 32 ml of water is displaced by a completely submerged object, that means the volume of the object is 32 ml as well (or 32 cc).
How many cups in 32ml?
0.13 cups.
A graduated cylinder has 32.0 mL of water in it A 3.0 cm3 rock is dropped into the graduated cylinder What is the new volume?
The rock's volume is simply the amount of water the rock displaced (52mL - 32mL), so 20mL. The density is mass over volume, so 40g/20mL, which simplifies to 2 g/mL: 40 divided by 20 is 2, and then the unit is just mass (g) over volume (mL).
If a beaker contains 32 liters of water what is the volume in milliliters?
Remember K H D | d c m (kilo, hecto, deka, (liter, meter, gram), deci, centi, milli). These are the denominations you need to list when converting metric units. Milliliters are three places to the right of liters. So you have to move the decimal place three times to the right (same as multiplying by 1000). You will get .32 L = 320 mL.
How much in ml is 32oz?
There are about 946 milliliters in 32 ounces.
How do I change Honda jazz wheel bearings?
I'm pretty sure you need to buy the whole hub unless you have specialist equipment to press the bearing out. I haven't done it yet but the nice gentleman at the local dealer said its a simple case of: 1) Remove the wheel. 2) Remove nut cap in centre (rounded cap, removed by lightly tapping with chisel/screwdriver and hammer) 3) Unscrew nut with a 32ml deep socket or wrench 4) Remove hub 5) Replace with new hub 6) Screw new nut that came with your new kit 7) Replace cap 8) Replace wheel 9) Drive
Removing a cv gator on a ford escort van?
Undo the 17ml pinch bolt holding the bottom ball joint on, hammer down on the lower arm to get the ball joint out of the hub.... Undo the 32ml hub nut (this will be tight) and then pull the hub towards you whilst gently tapping then end of the CV joint to get this out of the hub..... The tricky bit will be getting the CV joint off..... Clean the inside of the joint off (can get messy) and feel around for a circlip.... Use a pair of circlip pliers to open the circlip and then pull on the CV joint to remove it from the driveshaft and then pull the gaitor off...... To put the CV joint back on open the circlip again and then gently tap the CV joint on until the circlip locates itself on the groove on the driveshaft.
