before two alternators can be connected in parallel, the output voltage of the two machines should be the same, the phase rotation of the machines must be the same, and the output voltages of the two machines must be in phase.
They are different and unequal.
228ft
In multiplication, the numbers that are being multiplied together are called factors. Multiplication is the third basic mathematical operation of arithmetic, after addition and subtraction and before division.
You simply multiply the dimensions together. 5x7x15. Make sure the units match up before multiplying (they do in this example).
Depends on the type of vehicle you are driving, road conditions, driver reaction time, etc. The average car will take 121 feet to stop after the brakes are applied. Factor in reaction time and the car will travel 265 feet before it stops.
In my experience burning out alternators on a Pontiac and an Oldsmobile, you can get about 100,000 miles out of it before expecting to replace the alternator.
You ruined the alternator by disconnecting the battery while the car was running. I have seen alternators survive this but it is very bad! By the way this test procedure started damaging alternators in the 1960s when generators were phased out of production. This was a valid test procedure to see if the Generator was working before that time.
Paralleling transformers will increase the effective capacity available to the load. There are important requirements before transformers can be paralleled, so it's simply not the case of connecting any two transformers in parallel.
They worked long hours in dangerous conditions with no benefits.
The conditions were okay. They were having a governmental problems.
Before a hill and before entering
Before a hill and before entering
ugh
They worked long hours in dangerous conditions with no benefits.
They are different and unequal.
It was bad.
No. It is not uncommon for conditions to become unusually calm before a tornado strikes.