0
If you are using a 45 degree tool there's no need to set the tool post and you can just cut it by feeding the cross slide. If you are physically going to cut a chamfer with the compact slide, then you should set your tool post to 45 degrees.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What are the types of tool post?
the types of tool post on lathes can be classified as single screw tool post four bolt tool post open side tool post four way tool post
What is a square tool post?
tool post is used to handle the tool on the lathe machine
What formula do I use to set the angle on my lathe's tool post to cut a taper from a drawing?
A = Large end diameter of the taper B = Small end diameter of the taper L = Direct distance between A and B Formula: A \ B \ L \ 2 then Invert Tangent = The degrees you set your tool post at.
What is an American tool post?
An American style tool post is a square tool post designed for a center lathe. It can be rotated, is square and dove-tailed on all four sides. The dove tails allow tool holders with cutting tools clamped in it to be inserted and locked in place. This style of tool post decreases production time due to its ease of function and preset tool center heights.
What is end cutting edge angle in single point cutting tool?
It is the angle between face of the tool and a plane perpendicular to the side of the shank.It varies from 5 to 15 degrees.
What wood tool is used to mark a 90 degree angle?
a protractor
What tool is used for cheking 45 degrees angle?
A protractor, or a 45 degree triangle
Which tool is best suited for transferring a 35 degree angle from a drawing to a shop project?
it is a try square
What are the types of tool post?
the types of tool post on lathes can be classified as single screw tool post four bolt tool post open side tool post four way tool post
What tool cuts a 45 degree angle in a 2x4 plank of wood?
A miter saw. A skill saw will do it with some practice.
What is used to measure a angle?
the unit used to measure angle is degree. It is also measured in radians.
What is a square tool post?
tool post is used to handle the tool on the lathe machine
What is the purpose of a saw guide?
A speed square or rafter angle square is a tool that can be used as a saw guide. The purpose of this tool is to guide the saw when making short 45 and 90 degree angles.
What is the angle between face of the tool and plane parallel to the base of the tool called?
rake angle
How do you replace o2 sensor on a 2001 Jeep Wrangler?
Auto parts stores sell a special tool to help you get a good angle on it. The tool hooks up to your socket wrench but runs at 90 degree angle from there. The socket end has a slit through it which you run the 02 wire...
What is a tool for measuring an angle?
That tool is called a protractor.
How do you pick locks with safety pins?
straiten out the pin then cut the point off then bend one at a 90 degree angle one at a 120 degree angle and a wavy on 1. _| 2. _/ 3.~ hold the part of the lock that turns in the unlocking position, insert tool 3 to jiggle the pins, now insert tool 2 to work the back then tool 1 to do the front, simply push all then pins down until it opens.
