Any line divides the Cartesian plane into two parts. When deciding whether the line should be solid or dashed, think of the points on the line. If these points are not in the permitted region then it will be a dashed line, otherwise it will be a solid line. Usually this will mean that a strict inequality is dashed.
Leaders
The parallel lines represent scarification patterns.
No. Vertical lines are not.
The purpose of hidden lines is to represent edges that are not directly visible. The purpose of center lines is to represent the axes of circular features.
Hidden lines.
On a topographic map dashed lines can represent boundaries (e.g. national, state, etc). A dashed line can also represent a hiking trail or a telephone, or above-ground oil or gas line.The color and length of the dashes can distinguish between one type and another. Check the map legend to understand the exact meaning.
Each line time is used to show different things. Some of the lines are, Center lines( long- and short-dashed lines.)cutting plane lines( thin, medium-dashed lines, or thick long- and double short-dashed) and section lines(thin lines in a pattern).
it means to rush
It can represent the graph of a strict inequality where the inequality is satisfied by the area on one side of the dashed line and not on the other. Points on the line do not satisfy the inequality.
The Different drafting lines are the following:visible - are continuous lines used to depict edges directly visible from a particular angle.hidden - are short-dashed lines that may be used to represent edges that are not directly visible.center - are alternately long- and short-dashed lines that may be used to represent the axes of circular features.cutting plane - are thin, medium-dashed lines, or thick alternately long- and double short-dashed that may be used to define sections for section views.section - are thin lines in a pattern (pattern determined by the material being "cut" or "sectioned") used to indicate surfaces in section views resulting from "cutting." Section lines are commonly referred to as "cross-hatching."phantom - (not shown) are alternately long- and double short-dashed thin lines used to represent a feature or component that is not part of the specified part or assembly. E.g. billet ends that may be used for testing, or the machined product that is the focus of a tooling drawing.
line style
Perforated
An open circle should have a dashed circumference, a closed circle a solid one.
tesco
single yellow and dashed yellow parallel lines
Different types of lines are :parallel lines, intersecting lines, perpendicular lines,oblique lines, vertical lines, horizontal lines, zigzag lines, curved lines ,wavy lines, and dashed or dotted lines.