answersLogoWhite

0


Best Answer

Is the alternator a known good one? You could have a bad rectifier in your alternator causing a short to ground when it is installed.

User Avatar

Wiki User

โˆ™ 2008-02-16 05:42:14
This answer is:
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
User Avatar

Add your answer:

Earn +20 pts
Q: What do you do if a wire grounds out after you hook the alternator back on to a 1993 Saturn?
Write your answer...
Submit
Related questions

How do you replace the alternator on a 1993 VW Jetta III?

Remove the wiring harness from the back of your 1993 VW Jetta alternator. Remove the three alternator retaining bolts. Remove the alternator belt. Reverse the process to install your new alternator.


How do you replace a fuel gauge sensor in a 1993 Saturn?

the fuel guage in my 1993 Saturn goes wiggling back and forth. how do i fix this problem?


If the alternator is in the back of the motor how do you get to the alternator on a 94 saturn.?

Either take the front right tire off or jack the car up and go in from the bottom.


How do you replace the alternator on a 93 deville?

Remove the belt from your 1993 Cadillac Deville alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.


How do you replace alternator Mercedes 300d 1993?

Begin by removing the belt from your Mercedes-Benz alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.


Where is the oil pressure sending unit on a 95 Saturn sl1?

On the 1995 Saturn SL1 The oil pressure sending unit is the sensor closest to the alternator. The unit is on the back of the block.


How do you replace the alternator on a 1993 Buick Roadmaster?

Disconnect the battery. Remove the alternator belt. Disconnect the wiring on the alternator, then unbolt and remove the unit. Bolt the new alternator in place and connect the wiring. Install the belt and connect the battery back up.


Where is oil pressure sending unit on 2002 Saturn sl1?

The oil pressure sending unit is located on the back of the block. it is the sensor located closest to the alternator.


Have probes come back from Saturn?

No probes have come back from Saturn.


How to put on fan belt on 1993 Chevrolet pickup 305?

You have to take off the alternator to be able to reach the fan . After you should oiul the belt to slip on the fan very easy . Put the alternator back on and your ready to go .


Where do the wires go on a Vauxhall alternator?

from the back of the alternator to the dash to the battery


Why does my 1993 dodge caravan die out when hot It will turn right back on but continues to die already replace the coil ecm and alternator?

because it's old


Remove alternator on 1993 3.3 engine dodge caravan?

I have a 1993 dodge grand caravan, and have taken the alternator off of the bracket, but it will not fit down the back of the motorand under the fire wall. I have tried to remove the alternator bracket , but it looks as though it is trapped behind the tensioner pulley. I don't see how to remove the pulley bracket and don't know if this will work at all. What a crazy design! I hope someone out there can help.


How do you replace an alternator or vauxhall vectra?

You will need to remove the alternator belt. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install your new alternator.


Put back seat in 2002 Saturn L200?

How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it. How do I put the back seat bottom back in my 2002 Saturn L200? The Mechanic took it out and did not replace it.


Where is the alternator located on a 1992 Saturn?

you can see it from the passenger side under the hood find the power steering pump at the back by the fire-wall you'll see the pulley that is attached to the steering pump, then look just to the right and straight down looks like a fan pulley that is your Alternator


Where is the oil pressure switch located on a 1998 Saturn sc2?

the oil pressure switch is located on the back of the engine block closest to the alternator. it has a single Tan wire running to it, and a Grey connector.


How do you change the alternator on a 1995 Chrysler LHS?

Remove the wiring harness from the back of your 1995 Chrysler LHS alternator. Remove the alternator belt. Remove the alternator retaining bolts. The alternator will come off and can be replaced with the new alternator.


How do you replace alternator on a 1995 Infiniti g20?

The 1995 Infinity alternator can be replaced by removing the alternator belt. Removing the wiring harness from the back of the alternator. Removing the alternator retaining bolts. Put the new alternator on and reverse the process.


How do change an alternator on 1996 Ford Ranger?

Remove the alternator belt from your 1996 Ford Ranger alternator. Remove the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.


On a 1993 Chevy Corsica how do you get the serpentine belt back on after replacing the alternator?

ther is a tesionor pulley that releives pressure to the belt. it should take a 5/8 wrench


How do you replace the alternator on a 1992 Geo Prizm?

Disconnect the battery. Unplug the alternator and take the belts off. Unbolt the alternator, and bolt the new one in. Put the belts back on it. Plug it back in and reconnect the battery. Voila! You changed your own alternator!


What are some questions about Saturn?

there are a lot of question about Saturn but, one is does Saturn have rings? I will let you respond to me back for the answer.


How do you replace the voltage regulator on a 1993 GMC Suburban?

You may find it easier to just change out the alternator. If not, remove the alternator from the truck. Mark the case half's, so they can be put back together correctly. Remove the four screws that hold the two together. Pull the back half off. The regulator is mounted to the inside rear of back half. Unscrew the mounting screws, remove the regulator, and install the new one. Reassemble the alternator making sure the mark line up that you put on the alternator. The brushes may be held in place with a small drill bit, or even a round tooth pick will work. Push the brushes into their holders, and use the drill bit to hold them in place. There is a small hole that goes through the holders, and out the back of the case. Once alternator is back together, remove the drill bit. Reinstall the alternator to the engine.


How do you replace the alternator on a 1989 Mercury Cougar?

You can replace the alternator on your 1989 Mercury Cougar by removing the alternator belt. Disconnect the wiring harness from the back of the alternator. Remove the alternator retaining bolts. Reverse the process to install the new alternator.

Study guides

๐Ÿ““
Create a Study Guide