answersLogoWhite

0


Best Answer

It looks like a1989 Dodge dynasty! Go to your browser search, and type in pictures of 1989 Dodge dynasty and you will see what a 1989 Dodge dynasty looks like.

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What does a 1989 dodge dynasty look like?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What does a 1996 dodge dynasty look like?

Dodge did not make a 1996 Dynasty. The last Dynasty was built in 1993.


What does the solenoid from the 1991 dodge diplomat 318 look like and what other years solenoids are interchangeable?

There is no such thing as a 1991 Dodge Diplomat, last year for them was 1989.


What does the rear seal look like in a 1990 Dodge Dynasty?

It's a rubber seal about a quarter inch thick, and about three inches across... usually brown.


Where is the starter on a 1989 dodge d100 truck?

Look at the rear lower end of the engine


What does a 1996 dodge Aries look like?

Doesn't look like anything, as Dodge didn't make the Aries in 1996.


What does a 1989 3.9L Dodge Dakota crank sensor look like?

A 1989 Dakota uses the distributor pick up plate for the crank signal. It is the plastic plate under the rotor inside the distributor cap.


What does the Shang Dynasty flag look like?

The moon


What do cars look like?

Dodge Challenger:)


What does the outboard fuse and relay box look like in a 1989 Dodge Dynasty?

It should just be a box with a cover over it. Unsnap this cover and the relays and big amp fuses are inside the box. This box will be located in the engine compartment. It will be either on the left or right side on the engine compartment, but it usually near the battery. I hope this helps you. Good luck.Brad.


Where is the blower motor resister on a 1989 Dodge Dynasty and what does it look like?

It is located behind the glovebox, above the heater/AC box. The heater core and AC must be removed to get at it. Good luck. It would be a good idea to get a manual, as many parts need to be removed to change the resistor. If you are good at wiring, you may want to change the location of the resistor.


What is the proper Spark plug gap for a dodge dynasty 1992 3.3 V6 engine?

look on the underside of the hood there will be a sticker that says the gap


What do cool dodge vipers look like?

Like a snake in the face