It is where your electric panels are located and contains breakers that protect individual circuits that have various loads attached to them.
SMALL
4160 VAC three phase three-wire delta 50/60HZ electrical power
the load
A Resistor or Resistance
A switched load is an electrical load that has a switch ahead of it. This allows the load to be isolated from the electrical source. It could be a safety switch used for isolating machinery when maintenance needs to be done. A lighting fixture in your house could be classed as a switched load.
Load is simply any thing which dissipate electrical energy.
A load increases the flow of electrical current in a series circuit. No load, no flow.
Yes. In fact, in order to be used, the load center must either have a ground bus pre-installed or you must install one yourself. Without a ground bus, you would not have a way to properly ground your branch circuits and your entire electrical service/subservice.
Yes, you can run electrical wires in a load bearing wall.
Anything device can transform electrical energy into other form of energy. This is called an electrical load.
No it is not considered a load. A load transforms electrical energy into other types of energy :)
SMALL
The same name breakers as the manufacture of the load center.
a nonlinear electrical load, like a battery charger or water heater when present in a power system produces harmonics or rather distortions which leads to improper proportionality of voltage to current. so that's an electrical load
No it is not considered a load. A load transforms electrical energy into other types of energy :)
The load in a torch is tehb thin tungsten wire in the bottom of the torch. It converts electrical energy into light energy.
Frequency is set by the supply, not by the load.