== == factory ride height is all you should have in a Bronco II, they are top heavy! Answer: The height depends on what size tires you want to run. I'm running 31x1050x15s on my '84 Bronco ll. I am planning a 3" body lift. To run bigger tires you will need a body or suspension lift. As long as you don't do any radical manuvers ( backing up at high speeds while turning) you shouldn't have any problems. This site has alot of info on lifting your Bll. http://www.therangerstation.com/
The Eddie Bauer was an option ordered from Ford. It was the top of the line Ford Bronco from 1987 to 1996
yes ,but the interior door panels are different
if, you have the 2.9 it is 10 btdc
Full back soft tops for the Ford Bronco can be found on BroncoGraveYard.com.
6.5 front - 6x8 rear
To repair the head gasket on a 1987 Ford Bronco, the head and the old gasket must be removed. Purchase a new head gasket and carefully install it according to manufacturer specifications.
yes,if both are 2.9 motors,both are 4wd, and you are talking about the bronco2,not the full size bronco
yes they will interchange . you should have mo major problems switching them.
change out the heater core
mine can hold 32gallons
96 EB Bronco 5.8L EFI what is the standard fuel pressure
According to one of Fords websites : For a 1987 Ford Bronco , 4.9 liter / 300 cubic inch straight six cylinder : ( the spark plugs are gapped at .044 inch )
Probably not because the Ford Bronco and Ford Bronco 2 were not very good by their motor.
No there isn't. The Ford Bronco and Ford Bronco II have not sold very well and The Ford Motor Company is not interested on making a Ford Bronco III because of this situation.
Ford Bronco was created in 1966.
my 86 full size bronco haha
All 1978 and later Ford Broncos have interchangeable tailgates. I found this out grom the junk yard when I was looking for a replacement tailgate for my 1978 Bronco.
the cylinder or spark plug that sits farthest foword.gmjim
i wont swear by it but i think the 2.9 puts out 140 hp
I have a 1987 ford bronco and I changed the heater core in about 15 minutes. All you have to do is remove glove box and there is a panel with a few screws around it. and there you go.
aprox 5200 Lbs. varies slightly depending on model and options