# Bernoulli’s Energy Equation

## Problem 20 - Bernoulli's Energy Theorem

**Problem 20**

The 600-mm pipe shown in Figure 4-11 conducts water from reservoir A to a pressure turbine, which discharges through another 600-mm pipe into tailrace B. The loss of head from A to 1 is 5 times the velocity head in the pipe and the loss of head from 2 to B is 0.2 times the velocity head in the pipe. If the discharge is 700 L/s, what power is being given up by the water to the turbine and what are the pressure heads at 1 and 2?

- Read more about Problem 20 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 31571 reads

## Problem 19 - Bernoulli's Energy Theorem

**Problem 19**

A pump draws water from reservoir A and lifts it to reservoir B as shown in Figure 4-10. The loss of head from A to 1 is 3 times the velocity head in the 150-mm pipe and the loss of head from 2 to B is 20 times the velocity head in the 100-mm pipe. Compute the horsepower output of the pump and the pressure heads at 1 and 2 when the discharge is: (a) 12 L/s; (b) 36 L/s.

- Read more about Problem 19 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 29494 reads

## Problem 18 - Bernoulli's Energy Theorem

**Problem 18**

Figure 4-09 shows a siphon discharging oil (sp gr 0.90). The siphon is composed of 3-in. pipe from A to B followed by 4-in. pipe from B to the open discharge at C. The head losses are from 1 to 2, 1.1 ft; from 2 to 3, 0.7 ft; from 3 to 4, 2.5 ft. Compute the discharge, and make table of heads at point 1, 2, 3, and 4.

- Read more about Problem 18 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 17516 reads

## Problem 17 - Bernoulli's Energy Theorem

**Problem 17**

In Figure 4-08 is shown a siphon discharging water from reservoir A into the air at B. Distance 'a' is 1.8 m, 'b' is 6 m, and the diameter is 150 mm throughout. If there is a frictional loss of 1.5 m between A and the summit, and 1.5 m between the summit and B, what is the absolute pressure at the summit in kiloPascal? Also determine the rate of discharge in cubic meter per second and in gallons per minute.

- Read more about Problem 17 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 18283 reads

## Problem 16 - Bernoulli's Energy Theorem

**Problem 16**

A pump (Figure 4-07) takes water from a 200-mm suction pipe and delivers it to a 150-mm discharge pipe in which the velocity is 3.6 m/s. The pressure is -35 kPa at A in the suction pipe. The 150-mm pipe discharges horizontally into air at C. To what height h above B can the water be raised if B is 1.8 m above A and 20 hp is delivered to the pump? Assume that the pump operates at 70 percent efficiency and that the frictional loss in the pipe between A and C is 3 m.

- Read more about Problem 16 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 24007 reads

## Problem 15 - Bernoulli's Energy Theorem

**Problem 15**

A pump (Figure 4-07) takes water from a 200-mm suction pipe and delivers it to a 150-mm discharge pipe in which the velocity is 2.5 m/s. At A in the suction pipe, the pressure is -40 kPa. At B in the discharge pipe, which is 2.5 m above A, the pressure is 410 kPa. What horsepower would have to be applied by the pump if there were no frictional losses?

- Read more about Problem 15 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 23433 reads

## Problem 14 - Bernoulli's Energy Theorem

**Problem 14**

Water discharges through an orifice in the side of a large tank shown in Figure 4-06. The orifice is circular in cross section and 50 mm in diameter. The jet is the same diameter as the orifice. The liquid is water, and the surface elevation is maintained at a height h of 3.8 m above the center of the jet. Compute the discharge: (a) neglecting loss of head; (b) considering the loss of head to be 10 percent of h.

- Read more about Problem 14 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 27017 reads

## Problem 13 - Bernoulli's Energy Theorem

**Problem 13**

The 150-mm pipe line shown in Figure 4-05 conducts water from the reservoir and discharge at a lower elevation through a nozzle which has a discharge diameter of 50 mm. The water surface in the reservoir 1 is at elevation 30 m, the pipe intake 2 and 3 at elevation 25 m and the nozzle 4 and 5 at elevation 0. The head losses are: from 1 to 2, 0; from 2 to 3, 0.6 m; from 3 to 4, 9 m; from 4 to 5, 3 m. Compute the discharge and make a table showing elevation head, pressure head, and total head at each of the five points.

- Read more about Problem 13 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 18867 reads

## Problem 12 - Bernoulli's Energy Theorem

- Read more about Problem 12 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 14181 reads

## Problem 11 - Bernoulli's Energy Theorem

**Problem 11**

A horizontal pipe carries 30 cfs of water. At A the diameter is 18 in. and the pressure is 10 psi. At B the diameter is 36 in. and the pressure is 10.9 psi. Determine the head lost between the two points.

- Read more about Problem 11 - Bernoulli's Energy Theorem
- Log in or register to post comments
- 13447 reads