angular line are the straight lines and sharp points contain in any things....
An angle that forms a straight line has an angular measure of 180 degrees.
It is a line that goes through the vertex of the angle and divides the original angle into halves.
A reference line is a vertical or horizontal line in a graph, corresponding with user-defined values on the x-axis and y-axis respectively. Reference lines further aid the determination of angular and linear measurements.
It is the rate of change - with respect to time - of the angular displacement.
A line of poetry in which the meter and the meaning conclude with the end of the line.
Angular measurement between two line, when one of them is surface line and another is the line which connect a point on the surface to the peak of the object is known as angular elevation of that object with reference to the the perticular on the surface.
If a body is moving in a straight line then it would have angular momentum about any point which is not along its line of motion. The magnitude of the angular momentum would be its velocity times the perpendicular distance between the line of motion and the point.
'Angular displacement' is the angle by which the secondary line-to-line voltage lags the primary line-to-line voltage. It can be directly measured by constructing a phasor-diagram for the primary and secondary line-voltages for a three-phase transformer.
Film actor Gregory Peck has an angular jaw.The youngster asked her dad if doors were angular.After making an angular cut, the rest was a straight line.
Angular or attenuated.
Angular frequency differs from frequency by factor '2Pie'. It has the dimension of reciprocal time(same as angular speed). Its unit is radian/sec. Or you can simply say that angular frequency is the magnitude of angular velocity(a vector quantity).
An angle that forms a straight line has an angular measure of 180 degrees.
Angular displacement (sometimes called phase displacement) applies to three-phase transformers, whether a single three-phase transformer, or three single-phase transformers connected as three phase transformer bank. It is, to a three-phase transformer what additive/subtractive polarities are to a single-phase transformer.Angular displacement is one of a number of conditions that must be the same before two three-phase transformers (or transformer banks) are paralleled.'Angular displacement' is the angle by which the secondary line-to-line voltage lags the primary line-to-line voltage.Angular displacements for common connections are as follows:delta/delta transformers have an angular displacement of 0o or 180owye/wye transformers have an angular displacement of 0o or 180odelta/wye transformers have an angular displacement of 30o or 210owye/delta transformers have an angular displacement of 30o or 210oSo, for example, it is impossible to parallel a delta/delta or wye/wye transformer with a delta/wye or wye/delta transformer, as their angular displacements are different.Determining the angular displacement of a particular transformer configuration (wye-delta, etc.) can be done by drawing the phasor diagram for the complete transformer as follows:draw the primary phase voltagesdraw the primary line voltagesdraw the secondary phase voltagesdraw the secondary line voltagesmeasure the (angular displacement) between a secondary line voltage and its corresponding primary line voltage
Radians.Another AnswerIf you are referring to 'angular displacement' in the context of three-phase transformer connections, then it's defined as the angle by which the secondary line voltages lag the primary line voltages, and is measured in (electrical) degrees.
It is a line that goes through the vertex of the angle and divides the original angle into halves.
meaning of line out jack
Basically, angular points of a rectangle refer to the vertices in itself. They are so - called because at the vertices, an angle is formed. Any other point on the line is simply called a 'point' but the point where an angle is formed is called as 'Angular point'.