Capacity - Using the Compressor to Find the Amount of Cooling
Imagine the system is running with the key pressures and temperatures are being recorded at set intervals, say 15 seconds. Each set of readings transmits enough information to enable the computer to plot the cycle on the P-h diagram. The compressor efficiency and COP of the process at each time interval is calculated by the computer. To find out how much cooling is being done, the mass flow rate of the refrigerant is needed. The term Capacity is used to denote the quantity of cooling. Other terminology includes Heat Extraction Rate, or Cooling Effect. It is measured in kW (Btu/hr in the old days).Installation of a refrigerant flow meter would be an obvious method to find the mass flow rate, but this is costly, and intrusive. The compressor can be used as a flow meter. If the volume pumping rate of the compressor is known this will enable the mass flow rate to be found simply from the density of the fluid at the compressor inlet condition 2. Most compressors have a defined displacement (or swept volume), but the volumetric efficiency may not be known. Indeed loss of pumping by the compressor may be the object of the investigation. However there is one input which can be measured with good accuracy and at reasonable cost without disturbing the refrigeration system. This is the electrical power input to the compressor.
www.skinb5.com
Liters (Most European and Asian countries quote capacity of refrigerator in liters)
Centimetre.
A megabyte.
Centimeters.
It would be feet
Liters (Most European and Asian countries quote capacity of refrigerator in liters)
cups
Millilitres would be the most appropriate measure.
A kilolitre or megalitre if a large pond.
Gallons
Which measure is most reasonable for the amount of liquid a bowl will hold
Centimetre.
A megabyte.
Most refrigerators have a thermometer inside that will show the temperature. If there is not one, most stores sell refrigerator thermometers.
20 liters
The meter.
Centimeters.