"Rise per run" or something like that is the tangent function. Use your scientific calculator to calculate tan 30. Be sure to set your calculator to degrees first. Then - since you want the result in inches per foot - multiply this tangent by 12.
It is 0.087 feet = 1.05 inches, approx.
To express .25 inch per foot as a percent slope multiply rise over run times 100. This can be expressed rise/run x 100. rise=.25 inch run=12inches. So .25 divided by 12 times 100 equals 2.083 which can be rounded to 2.1 or simply 2% slope
The slope can be remembered as "rise over run". When the slope is an integer, it means that the rise over run is positive.
It is the slope.
Slope is rise over run, so if you have a rise of 2 and a run of 4, then the slope is 0.5. If the table gives rises and runs, then just follow the two until they meet, that should be the slope.
5.596 inches (rounded)
It is 0.087 feet = 1.05 inches, approx.
Slope is equal to rise over run. There are 12 inches in a foot, so 10 feet is actually 120 inches. Therefore, the slope is equal to 1/120.
It is approx 1.7 inches.
That is the Pitch or slope of the roof. It means that in one foot of horizontal measure you will have 5" of rise .
3/12 means rise of 3 inches for 12 inches or 1 foot. 2 feet would give you a rise of 6inches. The slope is 6^2+24^2=s^2 36+576=612 s=approximately 24.7386337537
It is most often expressed as a ratio of inches of rise per 12 inches of run. A roof slope that rises 4 inches for every 12 inches of run is a "4 in 12" slope, or 4/12 slope, or 4:12 slope.
The slope can be defined as rise over run. It is the degree at which a line goes up or down.
rise/run = tangent 15 degrees rise = tan(15) x 48 = 12.86 inches
The three parts of the continental margins are the Continental shelf, the Continental slope, and the Continental rise.
Rise over run is used to determine slope. It doesn't matter which number is bigger. It simply tells you how far up a slope climbs over what distance. So on a roof for instance, 4/12 means the roof climbs 4 inches higher every foot of width.
A standard bed length is 80 inches. To get a 30 degree rise, you need to raise head up by 40 inches (sine of 30 degrees x 80).