0
What is the smallest wire size for which overcurrent protection is specified in the Code?
Wiki User
∙ 11y ago
14 AWG
Wiki User
∙ 11y ago
Add your answer:
Earn +20 pts
What is a feeder circuit?
Definition from the National Electrical Code Article 100:Feeder. All circuit conductors between the service equipment, the source of a separately derived system, or other power supply and the final branch-circuit overcurrent device.Branch Circuit. The circuit conductors between the final overcurrent device protecting the circuit and the outlet(s).
Is it NEC code to have a water fountain on a GFCI protection?
Yes. NEC 2005 440.21
In which type of wiring is 14 awg the smallest permitted?
Several answers are possible here (this sounds like a test question, by the way). NEC 210.19(A)(4) says that branch circuits that are not for cooking appliances specified in 210.19, or specific-purpose loads specified in 210.2 shall not be smaller than #14 copper (#12 aluminum). 310.5 says that all wiring 0-2000 volts shall be minimum #14 unless otherwise permitted elsewhere in the code. There are perhaps other references too, these are two that come to mind.
Can you put a bathroom in a room that has the electrical panel in it?
absolutely not... Besides the fact that "absolutely not" is the common sense answer, the NEC strictly forbids electrical panels from being in bathrooms. There are very few other restrictions, including the fact that there is no restriction on how close to water a panel can be. But the restriction on panels in bathrooms stands tall.
How many pages are in the 2005 NEC Code Book?
The paperback version of the 2005 NEC code book has 792 pages. It is written by the National Fire Protection Agency. It is the standart for electrical and wiring regulations.
What is the minium branch -circuit wire size that may be installed in a dwelling?
Under modern code, the 14 AWG copper conductor is the smallest branch-circuit wiring size, based upon 15A overcurrent protection.
Need to find protection class code?
What is protection class code for Sparta, NJ
The total load 75 amps is continuous what size breaker is required?
This depends on your local electrical code, however the National Electrical Code and Canadian Electrical Code both state that you must derate circuits to 80% of their maximum electrical capacity, so for a load of 75 amps you must use overcurrent protection and wire rated for 93.5 amps, and since that doesn't exist you must upsize to 100 amps.
What does it mean in medical code NOS?
not otherwise specified
What is the protection class code for Marlin Texas?
The homeowners protection class code for Marlin Texas is "6"
What is the ICD-9 code for a labial lesion?
If specified, 624.8; if not specified, 624.9. Kate, CPC, CCS-P
What is the airport code for Port Protection Seaplane Base?
The airport code for Port Protection Seaplane Base is PPV.
How to find the smallest number in c code?
smallest = min (one_number, another_number); ...or... smallest = one_number < another_number ? one_number : another_number;
What does NOS mean in ICD-9 code?
not otherwise specified
The code standadard for this type of protection?
CONDOM! always use protection
What is the fire protection class code for joliet Illinois?
what is the protection fire class for joliet illinois zip code 60435
Can the load wires in an electrical service panel exit from the same end as the service cable and meet code?
Per the 2011 National Electric Code, Art 230 Services:230.7 states:"Conductors other than service conductors shall not be installed in the same raceway or service cable."Exception #1: Grounding conductors and bonding jumpers.Exception #2: Load management control conductors having overcurrent protection.
