YOU NEED TO REPHRASE THAT QUESTION.
Must be 6' from the shower.
To control a light with a switch, the switch has to be connected in series with the light fixture.
AnswerFor installations according to US and similar wiring codes: the level as other light switches in the rest of your house and next to the door opening.For installations according to UK wiring regulations: it is not permitted to position a normal shoulder-height light switch inside a bathroom.A switch for the light(s) in a bathroom, shower room or toilet can be positioned either 1) OUTSIDE the room at the level of other light switches in the rest of your house, next to the room's door opening, or 2) as a pull-switch mounted on the ceiling INSIDE the room, just inside the door opening.However, since the latest UK wiring regulations were issued, only a qualified and Licensed Electrician is allowed to install or modify electrical wiring in a bathroom, cloakroom/toilet, kitchen or any other kind of room where water taps ("faucets" in US parlance) sinks, baths, showers, etc. are installed.In the UK, a plate switch may be used if it outside the desigated zones (atleast 0.6m from the edge of the bath or shower and must be suitable for the location(IP rated)).a pull switch maybe mounted on the ceiling anywhere in the room NOT above the shower/bath.This does NOT apply for socket outlets which have to be a minimum of 3m from the bath/shower in the same room,Remember all new circuits MUST be RCD proteded in locations containing a bath or shower (other special locations apply!)
You would need to purchase a duplex switch. As for the pilot light look for a duplex switch that has a neon pilot light that is incorporated into the handle of the switch. When the switch is turned on the switch's handle will illuminate.
A single pole switch controls a light or outlet at one location. A 3 way switch controls a light or outlet from 2 locations.
if light is not going off, bad switch or short in wiring to light!!
It is not any different except that it cannot be located within reach of the tub or shower.
To switch from single to double spacing on a PC keyboard, you typically need to use the formatting options within the software you are using. In most word processing programs like Microsoft Word, you can find the line spacing option in the formatting toolbar where you can select double spacing. Alternatively, you can use keyboard shortcuts like "Ctrl + 2" to quickly change to double spacing.
The only difference (from what you have seen elsewhere, such as tub and shower, toilet and sink) is that the light switch is located near the door, outside of the bathroom.
It is the brakes light switch
where is brake light switch
To control a light with a switch, the switch has to be connected in series with the light fixture.
Light switch was created in 1884.
i think that the light switch is shorting out are the auto light switch shorting for the thumb switch
turn head light switch till it clicks and theses your dome light switch...
I can not understand your question.
(this should be a grammar question) Switch off the light(s).
pull out the light switch