0
What measure of center should you use to describe two data sets that are both symmetric?
Wiki User
∙ 8y ago
jnjnnin
Anonymous
Anonymous
bar graph
Add your answer:
Earn +20 pts
Should you use millimeters or meters to measure a fork?
You should use a ruler to measure a fork. Once you have the measurement, it's probably most convenient to describe it in units of centimeters or millimeters, but meters will also work just fine.
What should you use to measure the width of an American football field?
A tape measure.
What should be used to measure the diameter of a steel ball bearing as accurately as possible?
A vernier caliper should be used to measure the diameter of a steel ball.
Why should be done from the corners to the center of the nails?
nails
Can you measure a paperclip with kilometers?
You could measure the length or width of it but you would have a decimal. You should be using centimeters.
What is the general term that is used to describe components of a laptop that should be replaced by a service center?
lcds
Should you use millimeters or meters to measure a fork?
You should use a ruler to measure a fork. Once you have the measurement, it's probably most convenient to describe it in units of centimeters or millimeters, but meters will also work just fine.
Can a 5 lug Toyota rim go on a 5 lug Nissan car?
not usually.. but u need to measure the bolt pattern from the toyota to nissan from center to center skipping one hole and measure across, if toyota measures the same as nissan it should fit but make sure you measure the center hole where your hub axle fits, if its the same it will bolt..so there is a way
What size rug should you get your 14hh?
This will vary from horse to horse. To determine blanket size measure from the center of the horses chest to the center of it's tail and that should be the blanket size, if it is a odd number go up one size.
What temp should your car air conditioner blow and how do you measure it?
Between 37 and 49 (Fahrenheit), depending on the ambient air temperature. You measure it with a thermometer in the left center console vent.
Why should you always measure position at the bottom hook of spring rather than at the center of mass of the attached load?
at the bottom you will get some value which is positive while if you measure at the centre you will get zero length
Describe the properties of a normal distribution?
A normal distribution is symmetric and when looked at on a graph, the graph looks like a bell shaped curve. Approximately 95 percent of its values should lie within two standard deviations of the mean. Frequency of the data lies mostly in the middle of the curve.
Is the right side of the body bigger than the left side of the body?
The body should be bilaterally symmetric, meaning that it should be approximately the same on both sides.
Should you use AC or DC to measure a dryers voltage?
The meter should be on the AC scale. In Canada and US the reading should be 240 on the outside blade holes and 120 volt from the outside blade holes to the center blade hole. The U shaped pin is the ground. No voltage from it to the center pin.
What should a barometer measure when there is a tornado?
If a tornado passes near or over a barometer, it will measure a very rapid drop in pressure. How much the pressure drops depends on the strength of the tornado and how close the center of it comes tot he barometer.
A sentence for describe?
you should always know how to describe your answer
Describe the circumstances when a budget revision should allowed and when it should be refused?
describe when a budget revision should be refused.
