You need a 40 amp breaker for a range. From a 40 amp breaker, standard ranges have a three conductor #8 copper wire installed, terminating in a three pole four wire grounding receptacle. NEMA number 14-50R.
The wire you are looking for is a 3 conductor #10 copper wire.
You will need to use #8 wire.
If the wire to the switch is AWG #12 you need a 20 amp switch because it is a 20 amp circuit.
#3 copper.
8 AWG copper.
You need a 60 amp breaker.
You only need the remote wire if you have an external amp.
Yes a remote wire is necessary. You must wire the remote wire from the amp to and ignition source of power (a component which turns on when the ignition in the car is engaged.) i.e. the radio. The remote wire signals for the amp to power on.
You will need to use #8 wire.
If the wire to the switch is AWG #12 you need a 20 amp switch because it is a 20 amp circuit.
you need an amplifier first. decide where you want the amp, and wire it to that point. (amp comes with instructions for the wiring) once the amp is wired in, wire it to the radio(instructions come with amp) and screw it in. then locate where you want the sub(s) and wire it to that from the amp. almost all your instructions for installing subwoofers comes with the amp.
Its not as hard as people may think, but its only a few wires. u need a power wire from the battery to the amp. then a ground wire from the amp to a good solid spot on your chassi. then a remote wire from your radio to your amp....and thats it, just connect your speakers and enjoy.
You have to run the powers and grounds for the amp, do not forget to set up the remote wire either. then you will need to connect the amp to the CD player auxillary with the RCA's, then you just wire your sub to the amp.-Shocker
8 AWG is typical.
8 AWG copper.
You need a 60 amp breaker.
#3 copper.
2AWG.