Want this question answered?
A capital letter at 72 point font size is supposed to measure one inch height.the answer to the crossword puzzle, if that's what youre doing, is "point"
Shoes off, legs, buttocks, and back flat against the wall(good luck standing like that for long) now roll a pencil across the highest point on your head to make a small, hopefully erasable, mark on the wall behind you. Take a tape measure and measure floor to your mark et voila! your height!
two vertical poles of equal height stand on either of a roadway wich is 20 ft wide. At a point in the roadway b/n the poles, the elevation of the taps of the poles are 30 degree and 60 degree. Find the height of the poles?
Yes. Strictly speaking, though, the block in which the letter was cast would have been 10/72".
If this is a horizontal area, it must be its height.
An object's height is the measure of the distance between its lowest point and its highest point expressed in linear units.
To find the height of a triangle you measure it. It has to be from the middle of the base to the top point.
The height of the wave, above the rest position, is its Amplitude. Twice the amplitude is the distance from the deepest point to the highest point.
First you need the specification for this height. Then take a tape measure and a flat floor and measure from the floor to the specified point on the car.
No. Contour lines connect points of equal height.
A hand is a unit of measure that determines the horse's height at the highest point of the withers. One horse's hand is equal to 10.16 cm. So in 132 cm, there are 13.0 hands.
They measure to the point you place them to, they don't rely on a consistent pin height.
Altitude is a measure of the height of something above sea level, or above some point on Earth's surface.
A capital letter at 72 point font size is supposed to measure one inch height.the answer to the crossword puzzle, if that's what youre doing, is "point"
They measure the location of a point north/south of the equator.So ? Have you ever seen a police line-up on TV ? The lines on the background go left and right,but they measure the suspect's height, right ?
To measure the height of a 20-liter jerry can, you can use a measuring tape or a ruler. Place the jerry can on a flat surface and measure from the base of the can to the highest point. Ensure that the measuring tool is positioned vertically to get an accurate measurement. By doing so, you can determine the height of the jerry can in centimeters or inches.
A clinometer can be used to measure the angle of elevation on the top of the coconut tree. You then measure the distance, D, from your position to the point underneath the top of the coconut tree. Coconut trees are often not straight so this point may not correspond to its base. Then the height of the top of the tree from your eye level, H is given by the formula: H = D*tan(x) so that the tree's full height is H + h where h is the height of your eyes above the ground level.