I found one for my 1999 ZX2 at the dealership. Ran about $50. dealership
It could be due to a vacuum leak or a faulty idler or tensioner bearing on the serpentine belt.
Put a 3/8 inch ratchet in the tensioner and release the tension by pulling it towards you. slide the belt off the tensioner. You don't have to take it completely off. Take the bolt holding the tensioner to the engine off and take of the tensioner. To put one on it is the reverse of this.
try either getting the right size of belt or adjusting the tensioner(re-install, or get a new one)
I'm not a mechanic but I just had to have the belt tensioner replaced on my 99 ZX2. There are no other adjustments.
I believe it's every 80k. Make sure to replace the tensioner/spring assembly as well.
check you motor mounts and trans alignment your pulley shouldn't wobble with a new assembly
Yes, the engine in a 2000 Escort is NOT an interference engine.
Not possible. You have to remove the whole light assembly.
Probably not.
You cannot adjust the belt tension on a 2000 dodge grand caravan. This vehicle is equipped with an automatic tensioner. If tensioner is frozen or will not hold the belt tight, it must be replaced.
were is the turn signal located in a 2000 ford escort zx2
Yes if they are both manual or automatic.