0
From the battery to frame directly under the battery box. From the frame to the engine at the motor mounts with a short ground cable. Usually on the drivers side.
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Where is the ground wire for the dash cluster on a 1985 Corvette?
== ==
Where is the horn ground wire on a 1993 corvette?
the metal mount bracket is the ground
Does a 1990 corvette has a 2 wire IAT sensor?
The 1990 Chevrolet Corvette IAT sensor does have two wires. The sensor has a ground wire and a positive wire.
Where does ground wire connect to gauge panel on 1981 corvette?
there is no ground in a car electrical system.
Wipers quit working on 1981 corvette?
my wipers quit working, got a new wiper motor , it did not work either, found out that it has lost ground, attached a ground wire to engine and wiper motor and it worked.
What wire is the hot wire and ground wire in a 1990 cutlass supreme?
the hot wire goes to the starter and the ground wire bolts to the engine block.
Where is the ground wire for a1982 Chevy Celeberty?
The battery ground wire runs from the battery to the engine block.
Where is the ground wire on the alternator in a 1999 Pontiac Grand Am?
There is no ground wire.... it grounds through where it touches the engine
Where is the ground engine wire that goes to the chassis or car?
The ground wire leads from the negative side of the battery and connects either to the engine block or to the frame of the automobile.
Why don't the wipers work on a 1968 corvette have a new wipermotor new engine wire harness and new switch when switch goes to on you here a click under dash?
ground issue on wiper motor housing
How do you check an engine for spark?
Remove the spark plug wire from the spark plug. Use some heavy gloves or a set of insulated pliers to hold the spark plug wire about 1/4-inch from the engine block (ground) and crank the engine - you should see a spark jump from the wire to the engine ground. For a better check, use another spark plug and put it on the spark plug wire and use it as a "jumper" from the wire to the engine ground.
What could be the problem When the turn signals won't work and the car wont start but sometime they work and the car then starts?
Might be bad ignition switch?? Check the ground wire as well. Check and clean if corroded: The Ground strap/wire from the frame to the engine The small ground wire from the battery to the body The Ground wire from the battery to the engine.
