if you remove the coil cover on top of the distrubutor, there will be a red wire, a white/ or yellow wire, and a black wire which will be the ground. The Coil is not mounted on distributor in 93. It has a remote coil
There are many ground wires in the electrical system of that truck. We need to know which circuit you have a problem with.
Bolt The Coil Bracket And Coil To The Block, The - Goes To The Distributor The + Hooks To The Ignition.
The wire in center of distributor cap attaches to coil.
An ignition coil generally looks like a cylinder with a second cylindrical temp at one end. On top of that same and, there are two primary terminals. Inside of an ignition coil is an iron core surrounded by coils of thin wire.
follow the center wire out of the distributor cap
Chiltons Mazda trucks manual has the picture and explanation.
The ignition coil wire diagram can be found on Mustangs And Fords website (link to diagram below).
no
There is no coil wire. There is a coil pack and connected to the coil pack is the ignition control module.
The 1999 Jeep Cherokee ignition coil used a black wire for the negative wire. The negative wire should be on the left post.
The coils are bolted to the ignition control module, there is no coil wire as such.
vw golf ignition coil wire to burn out y
Is this a conventional coil, a hei coil, or a coil over each plug?? need more info, but is has a wire, hold approximately 1/4 inch from ground and see if archs, if High Energy coil, hold plug wire about 1/4 in from ground and see if fires, if coil over plug individualy, not sure how to check them. good luck
Easy way is to run the large out wire to a ground, one post on the coil to a ground and one to positive. Do not allow the large wire to actually touch the ground, have it just above the ground so that you can see a spark. Warning: do not touch the large wire while the other are hot. It has a lot votage and could possibly cause you to get injured.
If you see no center coil wire connector then the coil is mounted inside the distributor. If there is a center coil wire connecter then follow the coil wire and it will go to the coil.
Failed coil wire, failed rotor, failed capFailed coil wire, failed rotor, failed cap
A bad ignition coil can cause your 1987 Acura tachometer to quit working. A bad tachometer cable or ground wire can also cause it to quit working.
Primary wire comes from ignition key to hot side of coil.