Star topologa
Star topologa
Yes, in fact, that is a common way to set up a network.
Star Topology
Star topology:- In this topology all PC are connected with the central device. Central may be HUB and SWITCH. Star widely use in all over word. Ring topology:- In this ring topology all PC are connected in the frame of ring are close Ring topology use MSAU each PC has a two never road one is called up Stream and called down stream. It used token passing Matterhorn which implement the token ring network. " Is the best of star topology".
Star Topology is the most common type of network topology that is used in homes and offices. In the Star Topology there is a central connection point called the hub which is a computer hub or sometimes just a switch. In a Star Network the best advantage is when there is a failure in cable then only one computer might get affected and not the entire network.
Computers can be interconnected in different ways to form a network. Such different ways of interconneconnection are called computer topologies. There are 5 topologies. They are: * BUS TOPOLOGY * RING TOPOLOGY * STAR TOPOLOGY * MESH TOPOLOGY * TREE TOPOLOGY
A star network uses a central server to route data between clients. The central server (or the switching hub) switches data around the network. Data flow between the server and the nodes will therefore be relatively low. A typical star network are mainframe computers. Star topology, also known as star network, is a computer network topology. It is a common network setup where the computers and other devices on the network are connected to a central or master computer, also known as the hub.
in bus topology computers are connected with each other by a wire in a approximately strait manner..and if one computer stops working the whole network will stop. while in star topology every computer is connected with the host computer & much wire is require..and if any client computer tops working it will not effect the whole network.----ravi singh chauhan...7275974787
Topology refers to the way equipments are connected one to another. For example, in a star topology all machines are connected through a central connector (a hub or switch), in a full mesh every equipment is connected to every other equipment, etc.Topology refers to the way equipments are connected one to another. For example, in a star topology all machines are connected through a central connector (a hub or switch), in a full mesh every equipment is connected to every other equipment, etc.Topology refers to the way equipments are connected one to another. For example, in a star topology all machines are connected through a central connector (a hub or switch), in a full mesh every equipment is connected to every other equipment, etc.Topology refers to the way equipments are connected one to another. For example, in a star topology all machines are connected through a central connector (a hub or switch), in a full mesh every equipment is connected to every other equipment, etc.
It is connected by a network cable, switch and a router.
Such topology is called star.
Several variations of Ethernet exist. At some moment, a bus topology was quite common, but nowadays, a star or extended star - with a hub or switch at the center of the star - is more common.Several variations of Ethernet exist. At some moment, a bus topology was quite common, but nowadays, a star or extended star - with a hub or switch at the center of the star - is more common.Several variations of Ethernet exist. At some moment, a bus topology was quite common, but nowadays, a star or extended star - with a hub or switch at the center of the star - is more common.Several variations of Ethernet exist. At some moment, a bus topology was quite common, but nowadays, a star or extended star - with a hub or switch at the center of the star - is more common.