To minimize the risk of it falling (or being knocked) off the table.
apple=round, round=roll, roll=far as possible, far as possible=edge of table, edge of table=drop off point....
nail it into your deck or get ones that stretch over the edge
4.5 seconds thats one awnser but is the cat a sumo cuz then the table would break and he would fall faster
If it is a new meter stick you can place it at the end of the stick, otherwise if it is old or shows some wear you should measure from the 1 centimeter mark and then subtract one centimeter from the answer.
There is no such edge.
You should keep it 10 cm from the table so it doesn't do anything to the table like skid it or anything also so it doesn't break.
so it doesn't fall!!!!!!!!!!!!!!!!!!!!!!!!;) :)
It might fall, lyke duhhhhhhhhhhhhhh, get a clue dude
Only the friction between the object and the rotating table will be responsible to keep you off from sliding out on a rotating table.
by placing your microscope at least 10 cm from the table,you greatly reduce the risk of it being knocked over.or if for some reason it still gets knocked over you can catch it before it turns into a real disaster.
It is not good to tilt the microscope because if it is at the edge then say bye bye to your microscope. Because it will fall and you will have to pay ALOT of MONEY for it. Another reason is because it could fall on the table and crack the eye piece or any other glass parts of the microscope. Thanks for reading. REMEMBER SAFTEY FIRST! :)
Taking care of your microscope isn't very hard. You just have to make sure that you wipe down the surfaces regularly and when you carry it have one hand on the base and the other holding it's arm. Your Welcome! :)
]
It's necessary to scoot to the edge of the table so the doctor can get a good view of your vulva. If you're not at the edge of the table then the table is in the way and you're further away from the doctor so they can't get as close a look. Also your pelvic needs to be tipped up slightly, which requires you to be at the edge of the table with legs in stirrups.
what you do is get the two magnets on the edge of a table slightly hang the one you want separated off the edge then get a piece of square wood and puss down and that should do it!
When arranging one's work area for the day, there is a certain way that the keyboard should be placed. Specifically, the edge of the keyboard should be aligned with the edge of the desk. This keeps the wrists in the correct position for keying.
apple=round, round=roll, roll=far as possible, far as possible=edge of table, edge of table=drop off point....