Any device is designed most likely with some limitation of +-% A 10v is nothing to worry about however the current is something to worry about
What is your question? A standard outlet is 110V. A 220 outlet is shaped different so that you know it is 220. You would never run 220 through a 110 outlet.
You sure can. It will run a little faster.
You should be able to use it as is (assuming the plug matches your outlet). It will just run a little bit cooler at 220 volts vs. 230 volts.
depends on what the line is feeding. 220, 225, 230, 240, even 250 are all in the same catagory. power companies have increased their output voltages through the years. i would say 220 is minimum. if your connected load is a motor, they are more voltage sensitive, and should be run on 230 or 240. it makes the motor more effecient
Yes. They're essentially the same as 110-115-120 are the same. The power that comes into your house is 240V, but by the time it's transferred through wires and breakers and outlets, it drops to about 220-230V. So anything between 220-230-and-240 is the same thing.
No. Car stereos run on 12v DC power. A wall outlet, depending on where in the world you are, gives out either 110-120 or 220-240v AC power.
Usually a stackable washer and dryer system will need a special outlet. Dryers usually run on a 220 outlet so they will need a special outlet installed where you plan to place your washer and dryer.
That depends on what the suply is if your power suply is 230 then you run it on 230.
yes
== == It is important that you should read see the answer to the Related Question shown below: "Can a European 230 Volt 50 Hz appliance be plugged into a 240 Volt 60 Hz wall outlet in USA or Canada?" Not only will "most" 230 Volt units run on 220 Volts, but your 220 Volt outlet is probably 240 Volts!220, 230, 240 ... all the same thingThe number used only tells how old the inquirer is.Actual values reflect the commercial power transmission secondary envelope.The present standard, commonly referred to as 120/240 actually can be as high as 125/250! As always, if you are in doubt about what to do, the best advice anyone should give you is to call a licensed electrician to advise what work is needed. Before you do any work yourself,on electrical circuits, equipment or appliances,always use a test meter to ensure the circuit is, in fact, de-energized IF YOU ARE NOT ALREADY SURE YOU CAN DO THIS JOBSAFELY AND COMPETENTLYREFER THIS WORK TO QUALIFIED PROFESSIONALS.
No, it can run off 120 also. As long you have a unit that is built that way form factory. You should be able to tell this by looking at the label on the control box.
Yes if the house supply is 220-240 volts. The required voltage range should be printed somewhere on the fan.