rerfijrf
By using a protractor or using trigonometry
By using trigonometry
6.03 IS expressed using decimal form!
Using pemdas / gema
The profit of 27 using an integer is 12
Heres how i eventually did it ... 1. Using needle nose locking pliers i held the pipe to the muffler so that it wouldnt get knocked back into the muffler. 2. Then using a cold chisel i made a gap between the muffler (the part that houses the pipe) and the pipe. I did this so that the pipe could be cut through without also cutting the muffler. 3. Then using a power saw with a metal cutting blade i cut through the tailpipe. 4. Then I was the able to crimp the edges of the pipe up and pull it out. 5. Have a beer for a job well done !!!
alot of sound output depends on what muffler you are using, they normally sound abit louder than a chainsaw of the same displacement.
Either your muffler or resonator has corroded and the the fiber is no longer held securely by mesh. The fiber has blocked your muffler and in addition to considerable power loss, you will experience high fuel consumption. If you attempt to drive fast by using a fair bit of throttle your engine will run hot.
A muffler is a device used in the exhaust system of a vehicle to reduce noise produced by the engine. In a sentence, you could say, "The mechanic replaced the old muffler with a new one to make the car quieter."
speaking in a louder voice.
It would be a louder world without mufflers.
It isn't, its using Midas as a metaphor for its customers saving/getting money.
if you are using a higher flow muffler, it will not throw a code unless you put on a muffler that is more restrictive than the stock one (good luck with finding or even making one more restrictive) it will not throw a code.
Locate the sound, if it is high up on the engine it will most likely be the lifters, pretty common with the 4.0, you can quiet them down by using oil additives, but if it is low it may be a wrist pin knock, this will also happen and get louder when driving, and should be dealt with immediately.
Answer: Welded onBelow would be how to repair if the muffler has broken away from the exhaust pipe.If you have a welding machine:If your just attaching the muffler, You would need to attach the muffler to its hanger, then find a way to secure it to the exhaust so you can then weld it in place.If you do not have a welding machine:Most auto repair shops, have a welding machine so that they can do these kind of repairs if you lose your muffler, you can also purchase some special muffler/exhaust tape to tape around the break. Using the tape is a temporary fix.
A square scarf? Prolly a muffler scarf?
the engine is using its power to run the power steering pump