0
You can not get a tripped load circuit breaker in the secondary distribution center to reset what would be the next corrective action?
Genagenojoe
check for an overload or short
Wiki User
∙ 14y ago
Add your answer:
Earn +20 pts
What prevents the main circuit breaker and the mission essential circuit breaker of the secondary distribution center from being energized simultaneously?
an interlocking device
How many ground fault circuit GFCI circuit breakers are there in the circuit breaker panel of the secondary distribution center?
2
How many ground fault interrupter GFCI circuit breakers are there in the circuit breaker panel of the secondary distribution center?
2
What is the amperage rating of the mission essential power MEP circuit breaker of the secondary distribution center?
200 amps
What is the function of an LBB relay?
A local breaker backup relay is used to check the operation of distribution circuit breakers and to trip the feeder circuit breaker if the distribution circuit breaker fails to trip on an overload.
If the secondary distribution center is properly connected to a primary voltage source what happens when the main circuit breaker 4ACB is pushed the the ON position?
the three phase indicator lights will illuminate
What is the rating of the main circuit breaker of the 60kw power distribution panel?
200 amps
What is TPN MCCB?
A TPN MCCB is a three phase neutral molded case circuit breaker. This type of circuit breaker is commonly used in low voltage power distribution systems.
What is the smallest size circuit breaker found in the normal home?
The biggest circuit breaker in any home is the main breaker located in your main breaker panel that is installed where your electrical service cable comes into your home.
Is there a circuit breaker or relay for windshield wiper motor on 91' Lincoln town car?
Should be a breaker in the power distribution box under hood
What is the difference between ITE and FPE circuit breaker?
The connection blades and how they connect into the distribution panel's bus.
Why neutral is not required for vacuum circuit breaker?
Air-blast circuit breakers are used to disconnect high-voltage transmission or distribution circuits in the event of a fault. One circuit breaker is required for each of the three line conductors; there is not normally a neutral conductor in high-voltage three-phase transmission/distribution lines.
