No. Three phase service is something that you would need to request from your power company. You'd need to not only have service, you also need to have an electrician run 3 phase service into your home.
No, the plug configurations are different.
yes
From the nameplate on the welder you find the amperage that the welder draws at the three phase voltage that you are going to use. This amperage is used to size the phase converter. This amperage is also used to size the breaker that will feed the phase converter and wire size for the installation.
Yes, because you will be able to maintain current flow between phases.
Most 3-phase welders cannot be made to function on single-phase power. If your welder is an inverter type, such as a Miller Dynasty or Lincoln Invertec, then it may have a single-phase mode with reduced current output. You would have to download the manual for your particular welder. If it is an older transformer (big and very heavy), then you're probably out of options here.
pole=2 slots=24 phase=3 slot/pole/phase =6 (1)
PHASE 1...you believe in santa PHASE 2...you don't believe in santa PHASE 3...you BECOME SANTA
From the nameplate on the welder you find the amperage that the welder draws at the three phase voltage that you are going to use. This amperage is used to size the phase converter. This amperage is also used to size the breaker that will feed the phase converter and wire size for the installation.
Yes, because you will be able to maintain current flow between phases.
All my experience with rotary phase converters have been in converting 240 volt single phase into 240 volt three phase. They all were hard wired into their respective systems, so my answer is no.
Most 3-phase welders cannot be made to function on single-phase power. If your welder is an inverter type, such as a Miller Dynasty or Lincoln Invertec, then it may have a single-phase mode with reduced current output. You would have to download the manual for your particular welder. If it is an older transformer (big and very heavy), then you're probably out of options here.
See discuss question page below
3 bead cap
the basic principle of welding is 1. first we have some broken material 2. a welder 3. welder should know how to weld
pole=2 slots=24 phase=3 slot/pole/phase =6 (1)
A 2-pole wire will not work on a 3-pole plug. You will need to use a 3-pole wire on a 3-pole plug.
PHASE 1...you believe in santa PHASE 2...you don't believe in santa PHASE 3...you BECOME SANTA
use a rotor phaser or simply connect a 3 phase motor and check dirrection
Yes. With SOME, you may need a motor-generator set, or an inverter, to convert the single-phase power to three-phase power.... Some more modern 3-phase welders will operate directly on single-phase, because they're inverter-type units already. Many 'classic' transformer-based industrial welders can be made to operate easily off single phase power, at full output using the "Haas-Kamp Conversion". Do a web-search for Haas-Kamp and your welder's brand and model- if it's a popular welder, someone has probably already done it.